1) A transmission line with z, = 120o is terminated with a load Z. = 120 If the line is /4 long, ...
A lossless transmission line of electrical length l = 0.35λ is terminated in a load impedance as shown in the following figure, where ZL = 60Ω, and Z0 = 100Ω. Find: a) Relfection coefficient Γ, b) Standing wave ratio S (or VSWR), c) Input impedance Zin.
Problem 3. A lossless air-filled transmission line with Zo = 500 is terminated in a load with Z. = (100 +j25) 22. Determine the reflection coefficient, VSWR, and the input impedance 0.122 away from the load.
1) A lossless transmission line that is 3N2 long with an impedance of 75Ω terminated by a load of 25 Ω The generator has a voltage of V,r-2sin(et) V and an internal impedance Ζ'50Ω (a) For this circuit give Vg, T, and the voltage standing wave ratio. (b) Give Vin. Inand Vo (c) Give and I (d) Give the voltage and current at the midpoint of the line (ie. P(z) and I(2) at z-3/4). (e) From the answer of (d)...
Question 4 (a) The input impedance of a lossless air-core transmission line with characteristic impedance Ro. phase constant B and length I terminated in an impedance Z, is given by R,+Z, tan( i. Determine the length of an open circuit 50Ω line required to create a 0.1 nH inductor at a frequency of 10 GHz. (6 marks) ii. Determine the input impedance of the line in part () if the open circuit is changed to a short circuit. (3 marks)...
Please help! A 75-12 lossless transmission line has l = 0.752. An inductive load, Zl, is terminated where ZL = 75 + 75 12. (a) Find the standing wave ratio S on the line. (b) Find the load reflection coefficient, r(O), and the reflection coefficient seen at input, 7(1). (c) Find the input impedance of the line, Zin, for four different line lengths: 11 = 1/8, 12 = 9/4, 13 = 34/8, and 14 = 1/2, respectively. V(z), 7(z) ZO.B
9.45 In a laboratory experiment conducted on a 50-(2) lossless transmission line terminated in an unknown load impedance, it is found that the standing-wave ratio is 2.0. The successive voltage minima are 25 (cm) apart, and the first minimum occurs at 5 (cm) from the load. Find (a) the load impedance, and (b) the reflection coefficient of the load, (c) Where would the first voltage minimum be located if the load were replaced by a short-circuit?
A 75 coaxial transmission line has a length of 2.0 cm and is terminated with a load impedance of 37.575 If the relative permittivity of the line is 2.56 and the frequency is 3.0 GHz, find the input impedance to the line, the reflection coefficient at the load, the reflection coefficient at the input, and the SWR on the line.
2.2 A lossless transmission line of length 0.3A is terminated with a load impedance as shown below. Find the reflection cocfficient at the load, the SWR on the line, the return loss, and the input impedance to the linc. に0.3A ス14-40+/20 Ω
2 Tutorial (TL)teu 2 For a terminated transmission line consider that: Frequency 1 GHz, Phase velocity v 1.7x108 m/s, Physical line length L-11.9cm, Z- 100 92, Load impedance Determine: (a) the line length as a fraction of a wavelength (or otherwise called electrical length of the line), (b) the voltage reflection coefficient at the load and at the input to the line, (c) the input impedance to the line 2 Tutorial (TL)teu 2 For a terminated transmission line consider that:...
Please answer all parts. Thank you! (25 points) A half wavelength long 50 Ohm transmission line is terminated with a load of 100 Ohm. The voltage across the load is 16V 2. Determine standing wave ratio on the transmission line. Determine the incident voltage and reflected voltage at the load. Determine the incident current and reflected current a quarter wavelength away from the load. Determine the wave impedance a quarter wavelength away from the load. Design a matching network to...