Router R’s partial forwarding table is:
Partial Forwarding Table for Router R |
||
Destination |
Distance |
Next Hop |
Net1 |
2 |
Router T |
Net 2 |
3 |
Router S |
Router S sends the following partial update to Router R
Partial Update from Router S |
|
Destination |
Distance |
Net1 |
4 |
Net 2 |
6 |
What will be in Router R’s table after the update? Mark your change(s) directly on the Router R Partial Forwarding Table above.
Thanks
Routers R, S and T are interior routers in an autonomous system running RIP. Routers ...
Router R has the table shown below listing five destinations A-E, and three neighbor routers S, T, U. It updates its table using the usual distance-vector algorithm, where dist is the distance in hops. Original table: net dist nexthop A 5 S B 4 U C 6 T D 7 T E 8 S Suppose R receives the table below as its next distance-vector report from neighbor S. net dist A 4 B 3 C 4 D 7 E 9...
Neighboring routers J and K use the RIP routing protocol The original routing table (simplified for the purpose of this problem) in K is: Destination Distance Route Net 1 1 direct Net2 2 J Net 3 8 M Net 4 5 M Net 5 6 J Net 6 5 Q The update from J is: Destination Distance Net 2 3 Net 3 4 Net 4 2 Net7 5 Show the contents of the routing table in K after it has...
2) IP and MAC addressing. True or False. One point for each correct answer, zero points for each incorrect answer. Many of the questions refer to the following network consisting of three 10Mbps Ethernet segments, one switch, and one router. Assume all ARP tables are up-to-date unless otherwise stated. a) Consider a network consisting of Ethernets, hubs, switches, and routers. Suppose one of the hubs is replaced with a switch. Then the network administrator must redefine some IP addresses. True...
PLEASE ATTACH A SCREENSHOT OF YOUR SUCCESSFUL PING IN PACKET TRACER FOR THE END!!!!!!!!!!! THANK YOU! Objectives Part A: Configure a simple static routing . Part B: Configure a simple RIP routing Part A: Configure a simple static routing 1. Create the following network topology on Packet Tracer Router-PT Router-PT Addressing Table Device Interface IP Address Subnet Mask Default Gatewa 10.0.0.1 20.0.0.1 30.0.0.1 20.0.0.2 0.0.0.10 30.0.0.10 N/A 255.0.0.0 255.0.0.0 255.0.0.0 255.0.0.0 255.0.0.0 255.0.0.0 Routero 2/0 NIA NIA NIA 10.0.0.1 30.0.0.1...
EXPLAIN in details why is it true or false. need to be 100% POSTIVE OF ANSWER. SOLVE D E F G H I J 2) (10 points) IP and MAC addressing. True or False. Circle True or False. One point for each correct answer, zero points for each incorrect answer. Many of the questions refer the folowing network consisting of three 10Mbps Ethernet segments, one switch, and one router. Assume all ΛΕΡ tables are up-to-date unless otherwise stated Switch Ronter...
Q1 Error detection/correction Can these schemes correct bit errors: Internet checksums, two-dimendional parity, cyclic redundancy check (CRC) A. Yes, No, No B. No, Yes, Yes c. No, Yes, No D. No, No, Yes E. Ho, hum, ha Q2 CRC vs Internet checksums Which of these is not true? A. CRC's are commonly used at the link layer B. CRC's can detect any bit error of up to r bits with an r-bit EDC. c. CRC's are more resilient to bursty...
PART A 21 MARKS SHORT ANSWER QUESTIONS Answer ALL questions from this part. Write your answers in the Examination Answer Booklet. Each question is worth 1.5 marks (14 x 1.5 = 21 marks). Question 1 An organisation has been granted a block of addresses with the mask /22. If the organisation creates 8 equal-sized subnets, how many addresses (including the special addresses) are available in each subnet? Show your calculations. Question 2 Give an example of a valid classful address...
In this lab, we’ll investigate the 802.11 wireless network protocol. Follow the instructions and answers questions 7 - 10. http://gaia.cs.umass.edu/wireshark-labs/wireshark-traces.zip In this lab, we'll investigate the 802.11 wireless network protocol. Before beginning this lab, you might want to re-read Section 6.3 in the text. Since we l1 be delving a bit deeper into 802.11 than is covered in the text, you might want to check out "A Technical Tutorial on the 802.11Protocol," by Pablo Brenner (Breezecom Communications) http://www.sss-mag.com/pdf802_11tut.pdf, and "Understanding...