A three-phase full wave rectifier is supplied from a 420 rms line-to-line source. The load consists of a series connected 50 Ω resistor and 60 mH inductance. Determine the power delivered to the load by assuming that all harmonics are negligible.
NOTE :
a) If you find the solution doubtful or doesn't match with your answer provided, or you feel that I am wrong by any means feel free to mention that in comment. Otherwise your downvote will keep me in doubt. So that i can correct myself and it will also help me in future to guide others.
b) Please re-check the calculation and inform me if there is any error. Happy to help.
c) Some feedbacks or rating will help me to improve myself. Wish you all the best. Happy Learning. Thank You
A three-phase full wave rectifier is supplied from a 420 rms line-to-line source. The load consists of a series connected 50 Ω resistor and 60 mH inductance. Determine the power delivered to the load...
A balanced positive-sequence wye-connected 60-Hz three-phase source has line-to-line voltages of VL = 440 V rms. This source is connected to a balanced wye-connected load. Each phase of the load consists of a 0.5-H inductance in series with a 50-Ω resistance. Assume that the phase of Van is zero. home / study / engineering / electrical engineering / electrical engineering questions and answers / A Balanced Positive-sequence Wye-connected 60-Hz Three-phase Source Has Line-to-line Voltages ... Question: A balanced positive-sequence wye-connected...
Questions 1 to 3 relate to a three-phase SCR rectifier supplied from a 415 Vrms, 50 Hz ac source. For a 100 Ω resistive load, determine the peak, minimum and average load current for SCR firing angles of: (a) a-0° (5.87 A, 5.08 A, 5.6 A) (b) α = 45° (5.67 A, 1.52 A, 3.96 A) (c) α-70° (4.5 A, 0 A, 2.0 A) How will your answers change if a very large inductance (zero resistance) is added in series...
I just need answers to f,g,and h
connected motor is connected to Vi-L 120 3T/6 V-rms, 50 Hz three e resistance and inductance of each phase is 8-Ω and 0.04 H, respectively. The PS. A three-phase phase source. The wire between a source and the motor has 0.1-Ω of resistance and 1 mH inductance. nd the phase voltage. (2 pts.) a single-phase diagram of the system with its values. (5 pts.) c) Find the line current (magnitude and phase) for...
A three phase full-wave AC controller in Figure Q5(a) is supplied to a system with Y connected load system. The load consists of R = 100 and L = 0.01 mH which are connected in series between them. The line-to-line input voltage is given as 208 V with 50 Hz and the delay angle is given as a = 271/3. (1) Calculate the rms value of output phase voltage. (3 marks) (ii) Determine the power factor at output based on...
1. (10 PT) A three-phase bridge rectifier circuit shown in the figure phase voltage of 220 volts rms. A load of 100 Ω is connected across is supplied by a rectifier. Both the primary and secondary windings of transfor Assume the transformer has a turns ratio of unity mer are Y-connected a) 3 PTI On the top of voltage plot on next page indicate the diodes that will be conducting during different intervals of time. b) 17 PT] Plot the...
1. A half wave rectifier is supplied from a 100Vms source. For a load consisting of a 60V battery fed through a 2Ω resistor as shown in Fig. I 2Ω D+ + VR() bat Fig. 1 For the rectifier shown in Fig. 1, determine (a) a time varying expression for the current flowing into the battery 70.7sine -30 25.1 154.9) (b) (c) the average power flow into the battery (574W) the average power dissipation in the resistor (617W) A half...
1. A full-bridge three-phase SCR rectifier supplies an L-R load from a 208 V line-to-line 60 Hz source. The load draws 25 kW when the SCR phase delay angle is 60°. What is the pulse number for this rectifier circuit? Plot the load power as a function of delay angle for 0° < α 75°
A Δ-connected source supplies power to a Y-connected load in a three-phase balanced system. Given that the line impedance is (1 + j1) Ω per phase while the load impedance is (6 + j4) Ω per phase, find the magnitude of the line voltage at the load. Assume the source phase voltage Vab= 208 ∠0° V rms. The magnitude of the line voltage at the load is _______ Vrms.
A balanced three-phase source with a 208 V rms (line-to-line) is delivering power to a balanced Y-connected load with phase impedance Z1 = 4 + j 3 Ohms in parallel with a balanced delta-connected load with phase impedance Z2 = 7.5 + j 6 Ohms. Calculate the active (real) and reactive (imaginary) powers delivered by the source. Draw the power triangle. What is the power factor of the combined load?
A three-phase line, which has an impedance of (2 + j4) Ω per phase, feeds two balanced three-phase loads that are connected in parallel. One of the loads is Y- connected with an impedance of (30 + j40) Ω per phase, and the other is delta- connected with an impedance of (60 + j45) Ω per phase. The line is energized at the sending end from a 60-Hz, three phase, balanced voltage source of 120√3 V (rms, line- to-line). Determine...