Paper Design only!! output matehing In this assignment you are to design and implement in ADS two networks: an LC matchi...
5. Double Stub Matching Network Design a double shunt open-circuit stub matching network to match a load impedance Z, = 80-j60 Ω to a 50 Ω air-filled line operating at frequency f = 1 GHz、The distance between the stubs is,-/8. Sketch the resultant network and specify the line lengths in millimeters. 5. Double Stub Matching Network Design a double shunt open-circuit stub matching network to match a load impedance Z, = 80-j60 Ω to a 50 Ω air-filled line operating...
Stub Matching Netowrks Use a SMith chart to design an open-circuit shunt-stub transmision line single-stub matching network to transform a 50ohm termination to a load impedance of ZL=10+j30ohm with system impedance of 50 ohm. sketch the network, indicate the line lenghts on the sketch, and specify the stub and line lenghts in wavelenghts.
For a load impedance with ZL = 60-180 Ohm, design two single-stub shunt tuning networks (see Figure a) below) to match this load to a 50 Ohm source; use short-circuited stubs. Calculate transmission line and stub dimensions (length and width) if they are implemented as microstrip lines on FR4 which has thickness of 1.5 mm. ZIZ Figure 1. Single stub tuning circuits: a) shunt sub, b) series stub. (1) A. Behagl, RF and Microwave Circuit Design, Techno Search, 2017. ISBN...
6. Design two single-stub matching networks as shown below. Transform the load impedance Z (60 j45) Ω to match an input impedance of Z,-(75+j90)Ω. Assume that both the stub and the transmission line shown below have a characteristic impedance of Zo-50 Ω. Zot I ZoL.l ZL lm in Open or -) : short circuit , open or short circuit 6. Design two single-stub matching networks as shown below. Transform the load impedance Z (60 j45) Ω to match an input...