A 5 kg block is on a 52◦ inclined plane, where the coefficient of kinetic friction is µk = 0.46. A force of 30 N is applied along an axis parallel to the incline, as shown in the figure. The block is initially moving up the incline at 3 m/s.
a) Draw a free-body diagram for the block.
b) What is the acceleration of the block?
c) How far does the block travel before it reaches its highest point?
d) What happens to the block once it reaches its highest point? Draw a free body diagram for this situation and be sure to justify your answer.
Homework Answers
Dear student,
Find this solution.if any issue with that don't forget to write in comment section.I will rectify them as soon as possible.
If you find the solution helpful and kindly RATE THE ANSWER it would be appreciated.
Your rating is important to me.
Thanks for asking.
Add Answer to:
A 5 kg block is on a 52◦ inclined plane, where the coefficient of kinetic friction...
A block of mass m = 3.5 kg is on an inclined plane with a coefficient...
A block of mass m = 3.5 kg is
on an inclined plane with a coefficient of friction
μ1 = 0.31, at an
initial height h = 0.53 m above
the ground. The plane is inclined at an angle θ =
54°. The block is then compressed against
a spring a distance Δx = 0.11 m
from its equilibrium point (the spring has a spring constant of
k1 = 39 N/m) and
released. At the bottom of the inclined plane...
The coefficient of kinetic friction for a block of mass 45 kg sliding down an inclined...
The coefficient of kinetic friction for a block of mass 45 kg sliding down an inclined plane having an angle of 52 degrees to the ground is .03. Calculate the acceleration of the sliding block.
The coefficient of kinetic friction between the inclined plane and the block is 0.7. The has...
The coefficient of kinetic friction between the inclined plane and the block is 0.7. The has a mass of 15 Kq. It is observed that when the block passes a point located 2 ong the plane, it is moving at a velocity of 1.6 m/sec. a) What is the normal force of the block? b) What is the friction force acting on the block? c) What is the acceleration of the block? d) What is the velocity of the block...
Block 1 (20 kg) is pulled by a rope from left to right up a ramp...
Block 1 (20 kg) is pulled by a rope from left to right up a ramp which is inclined 30 degrees from the horizontal. The rope pulls on block 1 with a force of 220 N parallel to the surface of the inclined plane. The coefficient of kinetic friction between the block and the surface equals 0.1. On a sheet of paper, draw the free body diagram for block 1 using the two-subscript notation from class. Assume that the x-axis...
8. Block A is supported by an inclined plane at angle . The coefficient of kinetic...
8. Block A is supported by an inclined plane at angle . The coefficient of kinetic friction is 0.30 and the coefficient of static friction is 0.65 between the block and the surface. The pulleys are frictionless and the mass of the cord can be neglected. If both block A and block B weigh 25 lbs what is the maximum angle of incline for static equilibrium? . Α
A block with mass 12.0 kg is on a ramp that is inclined at an angle...
A block with mass 12.0 kg is on a ramp that is inclined at an angle of 50.0 degrees above the horizontal. The block is accelerating up the ramp at 3.0 m/s2 as you pull on it with a string parallel to the surface of the ramp with a constant force of 140 N.\ A) Draw a free body diagram for the block moving up the ramp and choose a convenient xy-coordinate system to apply Newton's laws of motion. B)...
less.) The coefficient of kinetic friction between block A and the inclined plane is Mk =...
less.) The coefficient of kinetic friction between block A and the inclined plane is Mk = 0.2. Initially the blocks are moving but eventually come to stop. You will be asked to solve for different things. Please pay attention: the numbers may change from problem to problem since they are randomized. 4) If block A weighs 90 lb and block B weighs 70 lb, and initially block A moves down the plane at a velocity of 7.2 ft/s, determine how...
The length of the A 2 kg block is released from rest at the top of...
The length of the A 2 kg block is released from rest at the top of a rough 40° inclined plane incline is 10 m. As the block slides down the incline, its acceleration is 3.0 m/s incline 1s 10 m. incline. Draw the free body diagram. a) Determine the magnitude of the force of friction acting on the bloc b) W hat is the speed of the block when it reaches the bottom of the inclined plane?
less.) The coefficient of kinetic friction between block A and the inclined plane is Mk =...
less.) The coefficient of kinetic friction between block A and the inclined plane is Mk = 0.2. Initially the blocks are moving but eventually come to stop. You will be asked to solve for different things. Please pay attention: the numbers may change from problem to problem since they are randomized. 4) If block A weighs 95 lb and block B weighs 55 lb, and initially block A moves down the plane at a velocity of 6.6 ft/s, determine how...
A 5 kg block is released from rest on a plane with a rough surface that...
A 5 kg block is released from rest on a plane with a rough surface that is inclined at 25 degree. The coefficient of kinetic friction between the block and the plate is 0.2 and the coefficient of state friction between the block and the plane is 0.5. Draw a free body diagram of the block. What is the acceleration of the block? For the system below, m1 = 10 kg and m2 = 15 kg. The table and pulley...
A block of mass m = 3.5 kg is
on an inclined plane with a coefficient of friction
μ1 = 0.31, at an
initial height h = 0.53 m above
the ground. The plane is inclined at an angle θ =
54°. The block is then compressed against
a spring a distance Δx = 0.11 m
from its equilibrium point (the spring has a spring constant of
k1 = 39 N/m) and
released. At the bottom of the inclined plane...
The coefficient of kinetic friction for a block of mass 45 kg sliding down an inclined plane having an angle of 52 degrees to the ground is .03. Calculate the acceleration of the sliding block.
8. Block A is supported by an inclined plane at angle . The coefficient of kinetic friction is 0.30 and the coefficient of static friction is 0.65 between the block and the surface. The pulleys are frictionless and the mass of the cord can be neglected. If both block A and block B weigh 25 lbs what is the maximum angle of incline for static equilibrium? . Α
less.) The coefficient of kinetic friction between block A and the inclined plane is Mk = 0.2. Initially the blocks are moving but eventually come to stop. You will be asked to solve for different things. Please pay attention: the numbers may change from problem to problem since they are randomized. 4) If block A weighs 90 lb and block B weighs 70 lb, and initially block A moves down the plane at a velocity of 7.2 ft/s, determine how...
The length of the A 2 kg block is released from rest at the top of a rough 40° inclined plane incline is 10 m. As the block slides down the incline, its acceleration is 3.0 m/s incline 1s 10 m. incline. Draw the free body diagram. a) Determine the magnitude of the force of friction acting on the bloc b) W hat is the speed of the block when it reaches the bottom of the inclined plane?
less.) The coefficient of kinetic friction between block A and the inclined plane is Mk = 0.2. Initially the blocks are moving but eventually come to stop. You will be asked to solve for different things. Please pay attention: the numbers may change from problem to problem since they are randomized. 4) If block A weighs 95 lb and block B weighs 55 lb, and initially block A moves down the plane at a velocity of 6.6 ft/s, determine how...
A 5 kg block is released from rest on a plane with a rough surface that is inclined at 25 degree. The coefficient of kinetic friction between the block and the plate is 0.2 and the coefficient of state friction between the block and the plane is 0.5. Draw a free body diagram of the block. What is the acceleration of the block? For the system below, m1 = 10 kg and m2 = 15 kg. The table and pulley...
Most questions answered within 3 hours.
-
26) Briefly describe, using words or simple diagrams, the
chemiosmotic theory for coupling oxidation to phosphorylation...
asked 1 hour ago -
Suppose that XX is a random variable with mean 16 and standard
deviation 5 . Also...
asked 2 hours ago -
Calculate the number density of argon gas at a temperature of
24C and a pressure of...
asked 5 hours ago -
Alternative
Classification
How to Estimate
Probabilities from Data? ( For continuous Attributes)
And How to generate...
asked 5 hours ago -
An explosion breaks a 20.0-kg object into three parts. The
object is initially moving at a...
asked 6 hours ago -
Calculate the approximate number of residues of Rubisco, which
is involved in carbon fixation in plants,...
asked 7 hours ago -
Other decisions about scientific claims can have a much broader
impact.ENERGYarrow-10x10.png, environment, health, security - all...
asked 8 hours ago -
I need to write a research paper and work cited about this
topic: The United States...
asked 8 hours ago -
Hello! I was wondering if I could have some help?
If the vapor pressure of carvone...
asked 8 hours ago -
An economist wants to estimate the mean per capita income (in
thousands of dollars) for a...
asked 9 hours ago -
What would be the input/output characteristic of a circuit
obtained by putting two of your 2's-complementers...
asked 9 hours ago -
In Drosophila, the transition from the syncytial blastoderm
stage to the cellular blastoderm stage is a...
asked 9 hours ago