A hand-operated control wheel made of aluminum has the proportions shown in the cross-sectional view (see gure on the right). The area of the total section shown is 15 200 mm2, and the wheel has a mass of 10 kg. Calculate the distance r to the centroid of the half-section. The aluminium has a density of 2.69 Mg/m3.
A hand-operated control wheel made of aluminum has the proportions shown in the cross-sectional view (see...
Cross-sectional View (current into page) A section of a long conducting cylinder with inner radius a and outer radius b carries a current lo that has a uniform current density, as shown in the figure above. (a) Using Ampère's law, derive an expression for the magnitude of the magnetic field in the following regions as a function of the distance r from the central axis. t. r<a ii. a<r<b (b) On the cross-sectional view in the diagram above, indicate the...
An open U-tube has water to a height h on both sides, as shown. The cross-sectional area of the left-hand tube is A1 = 1.50 cm2, and that of the right-hand tube is A2 = 0.50 cm2. A light oil (which does not mix with water) with a density of 0.83 g/cm3 is added to the right-hand side. When equilibrium is reached, which of the following is correct? PLEASE DONT COPY AND PASTE THE SOLUTION FROM THIS QUESTION THAT HAS...
326 СНАРТER 6 BENDING EXAMPLE 6.18 The reinforced concrete beam has the cross-sectional area shown in Fig. 6-39a. If it is subjected to a bending moment of M = 60 kip ft determine the normal stress in each of the steel reinforcing rods and the maximum normal stress in the concrete. Take Est = 29(10) ksi and Econc = 3.6(103) ksi SOLUTION Since the beam is made of concrete, in the following analysis we will neglect its strength in supporting...