What effect does increased altitude have on lift and drag forces at the beginning of the flight (if temperature and humidity remain the same)? A. The forces are decreased B. The forces are increased C. The forces remain the same
What effect does increased altitude have on lift and drag forces at the beginning of the...
A physic student sets out to experiment on the effect of drag forces on a ball of mass m by giving the ball an initial velocity nu_0 upwards and then downwards as describe below. In both cases, the ball experiences a force of air resistance whose magnitude is given by F = -k nu Where k is a positive constant. The positive direction for all vector quantities is taken to be upwards. Express all algebraic answers in terms of m....
The aerodynamic forces produced by a golf ball (lift and/or drag) depend on its diameter d, its speed V, its angular velocity w, and its dimple height h, as well as the air density p and viscosity . (a) You wish to define a force coefficient (a dimensionless force). Find an variables by which you can divide the force to make a dimensionless force coefficient. Show your work. appropriate combination of the above (b) Show that the appropriate dimensionless force...
If a reflector is added to the outside of a reactor, what effect does it have on the thermal flux at the edge of the reactor? Increased flux decreased flux Only effects fast flux
What effect does increased cytosolic Ca2+ have in the cytoplasm? Where does the calcium come from and where does it return?
concorde concorde supersonic transport flew at mach 2.2 at 20km altitude. concorde had four engines, each of which produces a thrust of 170kN. it mass on take -off was 185 tons and fuel was consumed at a rate of 22.6tons/h a) what is the Mach angle? b) How far behind the aircraft was it heard in the ground(take the atmosphere to have constant sound speed equal to 340m/s)? c) what was the ratio of lift to drag 2hours into flight?
The use of well-graded aggregate can have the following effect on concrete: a)Increased concrete shrinkage b) Increased concrete resistance to freezing and thawing c) The need for a lower amount of cement paste d) Decreased concrete shrinkage e) c and d
Assuming gas molecules in a container with a movable end (a piston), what effect will each of following changes have on the specified variable? 1-The effect on pressure when more gas molecules are added with the volume and temperature held constant. 2-The effect on pressure when the temperature is increased with the volume and number of molecules of gas held constant. 3- The effect on pressure when the volume is increased with the temperature and number of molecules of gas...
The lift and drag graphs of the model airplane weights.7 lbf are shown in Fig 6.1 and 62 below Figure 6.1 Lift vs angle of attack of thae jet fighter mode Figure 6.2 Dig v angle of attack of the jet fighter model 1.2 08 500 0400 06 04 02 100 024610 12 14 16 18 20 22 24 0 24610 12 14 16 18 20 22 24 a C) 20MPH Determine: Figure 63 LD i angle of attack of...
A helium balloon is used to lift a load of 106 N. The weight of the envelope of the balloon is 51.5 N and the volume of the helium when the balloon is fully inflated is 33.9 m3. The temperature of the air is 0°C and the atmospheric pressure is 1.00 atm. The balloon is inflated with a sufficient amount of helium gas that the net upward force on the balloon and its load is 30.6 N. Neglect any effects...
A helium balloon is used to lift a load of 100 N. The weight of the envelope of the balloon is 45.0 N and the volume of the helium when the balloon is fully inflated is 31.8 m3. The temperature of the air is 0°C and the atmospheric pressure is 1.00 atm. The balloon is inflated with a sufficient amount of helium gas that the net upward force on the balloon and its load is 31.2 N. Neglect any effects...