The pressure exerted by a phonograph needle on a record is surprisingly large. If the equivalent...
The pressure exerted by a phonograph needle on a record is surprisingly large. If the equivalent of 1.30 g is supported by a needle, the tip of which is a circle 0.240 mm in radius, what pressure is exerted on the record in N/m2?
______N/m2
Homework Answers
Add Answer to:
The pressure exerted by a phonograph needle on a record is
surprisingly large. If the equivalent...
The pressure exerted by a phonograph needle on a record is surprisingly large. If the equivalent...
The pressure exerted by a phonograph needle on a record is surprisingly large. If the equivalent of 0.500 g of mass is supported by a needle the tip of which is a circle 0.180mm in radius, what pressure is exerted on the record in N/m2? _N/m2
Solve and please explain steps elaborately (17%) Problem 2: The pressure exerted by a phonograph needle...
Solve and please explain steps elaborately
(17%) Problem 2: The pressure exerted by a phonograph needle on a record is surprisingly large, due to the very small width of the needle If the equivalent of 0.95 g is supported by a needle, the tip of which is a circle 0205 mm in radius, what pressure is exerted on the record, in pascals? Grade Summary Deductions Potential 92 ted cotan asin0 acos0 atanO acotan sinh0) cosho tanh0 cotanhO 7 8 9...
A patient in the hospital is receiving a saline solution through a needle in their arm....
A patient in the hospital is receiving a saline solution through a needle in their arm. The needle is 2.20 cm long, horizontal, with one end in a vein in the arm, and the other end attached to a wide tube that extends down from the bag of solution, which hangs from a pole so that the fluid level is 90.0 cm above the needle. The inner radius of the needle is 0.250 mm. The top of the fluid is...
A person pushes with a force of 10.0 N on a stick pin to try to...
A person pushes with a force of 10.0 N on a stick pin to try to push it into a bulletin board. If the tip of the needle is a circle with a radius of 0.12 mm, then what is the average pressure on the board at the tip of the pin 2.120E + 08 Pa 1.685E + 08 Pa 2.495E + 08 Pa 2.526E + 08 Pa 1.931E + 08 Pa 2.236E + 08 Pa An object has a...
Need help with #9 I know the answer is C but I’m not getting that answer...
Need help with #9 I know the answer is C but I’m not getting
that answer when I try and solve it
s. weighs 20 N and is held wire? up by a wire as shown below. What is the tension in the A) 60N B) 50 N 45 N 25 N 20 N sin53 Sns3 530 Suppose you pour water into a container until is reaches a depth of 40 cm. Next, you pour in a 30 cm thickness...
A large-capacity faucet is to be connected to a water main by 20-mm-diameter copper tubing as shown in figure. The copper tubing has an estimate surface roughness of 0.003 mm, and local head loss...
A large-capacity faucet is to be connected to a water main by 20-mm-diameter copper tubing as shown in figure. The copper tubing has an estimate surface roughness of 0.003 mm, and local head losses are created by the corporation stop (C-stop), four bends, and the faucet itself. The faucet exi diameter of 12 mm. What minimum pressure in the water main is require obtain a desired flow rate of 50 L/min when the faucet is wide open? At 20°C, the...
Need help filling in my data sheet from a lab. My professor said the pressure was...
Need help filling in my data sheet from a lab. My professor said
the pressure was 24.6 inches of Hg and that we needed to convert
that to moles. Im not sure i put that in the correct spot. I
included the lab protocol. Plz plz plz help me fill in the blanks
and let me know if i did something wrong Im very confused haha.
THANKS!!
Equivalent Mass by Electrolysis If the two terminals on any source of DC...
In a water pistol, a piston drives water through a larger tube of radius 1.30 cm...
In a water pistol, a piston drives water through a larger tube of radius 1.30 cm into a smaller tube of radius 1.10 mm as in the figure below. A diagram shows the interior of a water pistol pointing to the right, and the flow of water through it. The left end of the trigger is connected to the piston on the right end of a cylinder. The left end of the cylinder is connected to a tube, such that...
Problem 12.3. Evaluation ofpool boiling conditions at high pressure (Section 12.4) 1. A manufactu...
Answers are provided, need detailed solutions.
Need help with 2).
Problem 12.3. Evaluation ofpool boiling conditions at high pressure (Section 12.4) 1. A manufacturer has free access on the weekends to a supply of 8000 amps of 440 V electric power. If his boiler operates at 3.35 MPa, how many 2.5 cm diameter, 2 m-long electric emersion heaters would be required to utilize the entire available electric power? He desires to operate at 80% of critical heat flux. 2. At...
What is the volume of the sphere in Procedure 2 in units of cm3? Express your...
What is the volume of the sphere in Procedure 2 in units of
cm3? Express your answer to two significant figures.
LAB 14: IDEAL GAS LAW BASIC CONCEPTS TEXTBOOK: SECTIONS 15.2, YOUNG, 10TH EDITION DEFINITIONS Volume: The space taken up by an object, measured in cubic meters (m"). Pressure: For an enclosed gas, pressure is defined as the force exerted per area by the gas on the container walls, measured in Pascal (1 N/m) Temperature: A measure of the average...
Solve and please explain steps elaborately
(17%) Problem 2: The pressure exerted by a phonograph needle on a record is surprisingly large, due to the very small width of the needle If the equivalent of 0.95 g is supported by a needle, the tip of which is a circle 0205 mm in radius, what pressure is exerted on the record, in pascals? Grade Summary Deductions Potential 92 ted cotan asin0 acos0 atanO acotan sinh0) cosho tanh0 cotanhO 7 8 9...
A patient in the hospital is receiving a saline solution through a needle in their arm. The needle is 2.20 cm long, horizontal, with one end in a vein in the arm, and the other end attached to a wide tube that extends down from the bag of solution, which hangs from a pole so that the fluid level is 90.0 cm above the needle. The inner radius of the needle is 0.250 mm. The top of the fluid is...
A person pushes with a force of 10.0 N on a stick pin to try to push it into a bulletin board. If the tip of the needle is a circle with a radius of 0.12 mm, then what is the average pressure on the board at the tip of the pin 2.120E + 08 Pa 1.685E + 08 Pa 2.495E + 08 Pa 2.526E + 08 Pa 1.931E + 08 Pa 2.236E + 08 Pa An object has a...
Need help with #9 I know the answer is C but I’m not getting
that answer when I try and solve it
s. weighs 20 N and is held wire? up by a wire as shown below. What is the tension in the A) 60N B) 50 N 45 N 25 N 20 N sin53 Sns3 530 Suppose you pour water into a container until is reaches a depth of 40 cm. Next, you pour in a 30 cm thickness...
A large-capacity faucet is to be connected to a water main by 20-mm-diameter copper tubing as shown in figure. The copper tubing has an estimate surface roughness of 0.003 mm, and local head losses are created by the corporation stop (C-stop), four bends, and the faucet itself. The faucet exi diameter of 12 mm. What minimum pressure in the water main is require obtain a desired flow rate of 50 L/min when the faucet is wide open? At 20°C, the...
Need help filling in my data sheet from a lab. My professor said
the pressure was 24.6 inches of Hg and that we needed to convert
that to moles. Im not sure i put that in the correct spot. I
included the lab protocol. Plz plz plz help me fill in the blanks
and let me know if i did something wrong Im very confused haha.
THANKS!!
Equivalent Mass by Electrolysis If the two terminals on any source of DC...
Answers are provided, need detailed solutions.
Need help with 2).
Problem 12.3. Evaluation ofpool boiling conditions at high pressure (Section 12.4) 1. A manufacturer has free access on the weekends to a supply of 8000 amps of 440 V electric power. If his boiler operates at 3.35 MPa, how many 2.5 cm diameter, 2 m-long electric emersion heaters would be required to utilize the entire available electric power? He desires to operate at 80% of critical heat flux. 2. At...
What is the volume of the sphere in Procedure 2 in units of
cm3? Express your answer to two significant figures.
LAB 14: IDEAL GAS LAW BASIC CONCEPTS TEXTBOOK: SECTIONS 15.2, YOUNG, 10TH EDITION DEFINITIONS Volume: The space taken up by an object, measured in cubic meters (m"). Pressure: For an enclosed gas, pressure is defined as the force exerted per area by the gas on the container walls, measured in Pascal (1 N/m) Temperature: A measure of the average...
Most questions answered within 3 hours.
-
are primates eutherians?
i know eutherians come from therians but does primates come from
eutharia bc...
asked 3 minutes ago -
Calculate the specific heat of a certain unknown metal, if it
requires 195 joules of heat...
asked 14 minutes ago -
Identify the characteristics of a successful
project.
Describe the phases the project lifecycle.
Define the roles...
asked 24 minutes ago -
1. In Module 2 "headers" and "footers" are
described. Explain the difference between them and how...
asked 19 minutes ago -
Three polarizing filters are stacked with the polarizing axes of
the second and third at 58.5...
asked 27 minutes ago -
The capacitance in a series RCL circuit is C1 = 3.3 μF, and
the corresponding resonant...
asked 37 minutes ago -
A 357.7-gram sample of an unknown substance (MM = 92.41 g/mol)
is heated from -23.1 °C...
asked 37 minutes ago -
The project aims to design a network for a casino. The casino
has 10 floors including...
asked 42 minutes ago -
Combustion of an unknown compound containing only carbon and
hydrogen produces 54.9 g of CO₂ and...
asked 57 minutes ago -
A basketball player achieves a hang time, the total time of
flight, of 0.748 s when...
asked 58 minutes ago -
A processor of carrots cuts the green top off each carrot,
washes the carrots, and inserts...
asked 1 hour ago -
Please help me find the coefficient of kinetic and static
friction of two masses (500kg and...
asked 1 hour ago