a)
A = 8
======
b)
time period of wave,
T = 0.2 seconds
=======
c)
f = 1/ T = 1/ 0.2 = 5 Hz
========
d)
x = A sin ( pi/2 + 2 pi f t)
x = 8 cos ( 2* 3.14* 5* t)
x = 8 cos ( 31.4 t)
========
do comment in case any doubt, will reply for sure.. Goodluck
Problem 1 Consider the sinusoidal signal x(t) shown below. 10 8 4 2 4 6 8...
Problem 2 Consider the sinusoidal signal x(t) shown below. 10 8 6 4 2 -2 4 6 -10 0 0.2 0.4 0.6 0.8 1 1.2 1.4 1.6 1.8 2 2.2 2.4 2.6 2.8 3 t (seconds) Write an equation for this signal.
Problem 2 Consider the sinusoidal signal x(t) shown below. 10 8 6 4 2 x-2 4 -6 8 -10 0 0.2 0.4 0.6 0.81 1.2 1.4 1.6 1.8 2 2.2 2.4 2.6 2.83 t (seconds) Write an equation for this signal.
Problem 5 Consider the signal y(t) shown below: 4 3 2 0 2 -3 -4 0 0.2 0.4 0.6 0.8 1 1.2 1.4 1.6 1.8 2 2.2 2.4 2.6 2.8 3 t (seconds) Write an equation for y(t) in the form y(t)-A cos(ω°1+ φ) where you determine A, ω° and φ from the plot.
1. The above two plots show a sinusoidal signal and its spectral content respectively. What is the frequency of the sine wave (and in what units)? 2. What is the largest sampling period (in seconds) that could be used without aliasing for the signal provided. Explain how you obtained the answer. Signal: y-sin(2rft) 0.8 0.6 0.4 ? 0.2 0.2 0.6 0.8 t - [seconds] 25 Spectral Density: IY(fl 20 15 10 Frequency -1?]
Problem 2. Consider the sinusoidal voltage given by v(t) = 25 cos(400nt + 60°) V. a. What is the maximum amplitude of the voltage? b. What is the frequency in hertz? c. What is the frequency in radians per seconds? d. What is the phase angle in radians? e. What is the phase angle in degrees? f. What is the period in milliseconds? g. What is the first time after t=0 that v=0?
Problem 6 10 Points Your system samples a sinusoidal signal (t) cos(2T800t) with f 600 samples per second. After sampling, the reconstructed signal appears as a sinusoid at what frequency in Hertz?
Consider two sinusoidal currents ?2(?) = 10 cos(10??) mA ?3(?) = 10 sin(10??) mA where t is in seconds. (i) Find the total current given by ?(?) = ?2(?) + ?3(?) (ii) Determine the amplitude, frequency (linear & angular), period, phase angle, and time shift of ?(?)
II. Consider a continuous time signal x(t), containing two windowed sinusoids 0.1 0.2 0.3 0.4 0.5 0.6 The Fourier transform of the signal is as follows: 15 10 5 -800-_-400 h 200 400 600 The signal x(t) is the input of an LTI filter with frequency response lH(c) shown below 0.5 -&- 400︺-200 0 200 400 600 Shown below are four possible outputs of LTI filter when x(t) is the input. Please select the correct output (a) ya(t) (b) y(t)...
Kindly provide calculation and show each step. Thanks (a) Given the signal x(t) in Figure 2, sketch the signal for: xit) 12 10 - 2- 0.2 0.4 0.6 2 14 1.6 1.8 2 0.8 Figure 2 i. x(t+2) [4 Marks] ii. x(t/3) [4 Marks] iii. x(2t) [4 Marks] iv. -X(t) [4 Marks] (b) Given the signal x(t) in Figure 3, sketch the signal for x-(2t-2): xit 25 2 1.5 1 0.5 -0.5 0.5 1 1.5 2 2.5 3.5 Figure 3...
A signal is said to be a periodic signal if the S(t) = S(t+T), where T is the period of the wave. What is the period of a signal in common terms? Re-write the equation for a sinusoidal wave with half the amplitude and twice the frequency of s(t )