(Conservation of energy)
2007 80 1":ofwater attac 7.A2"glead ball at a temperaturrof842てis placed in alutalerinner Find the equibrium temperature...
Homework 7 heat transfer 2018-20 1) A horizontal tube of 12.5-mm dimeter with an outer srface temperature of 240°C is placed in a room with an air temperature of 20°C. Estimate the heat transfer rate per unit length of the tube due to free convection. 2) Air at -10°C flows at 10 m/s over the roof plate of two 5m length rooms whose air is at Too-200C. The roof plate is 0.20-m thick concrete (k = 0.6 w/ m. K)....
Please answer question 6. thanks 1. A 7 kg lead sphere that has 35 °C temperature falls through the air. When the sphere is 15 m above the ground, its speed is 20 m/s. Suppose that when the sphere hits the ground, 75% of its kinetic energy converts to heat that raises its temperature. Specific heat capacity of lead c = 128 J/kg.°C, g=9.8 m/s. A. Setup with a labeled diagram. b. Write down in symbols the energy equation. c....
A right triangle has hypotenuse 13 cm and one side 7 cm. Find the length of the other side, and the sine, cosine and tangent of each of the other two angles. A man running 4 m/s is passed by a car at 20 m/s, both heading East. What is the velocity of the man relative to the car? How far apart are the 20 seconds after the car passes the man? A ball is thrown vertically upwards from the...
summatize the following info and break them into differeng key points. write them in yojr own words apartus 6.1 Introduction—The design of a successful hot box appa- ratus is influenced by many factors. Before beginning the design of an apparatus meeting this standard, the designer shall review the discussion on the limitations and accuracy, Section 13, discussions of the energy flows in a hot box, Annex A2, the metering box wall loss flow, Annex A3, and flanking loss, Annex...
summarizr the followung info and write them in your own words and break them into different key points. 6.5 Metering Chamber: 6.5.1 The minimum size of the metering box is governed by the metering area required to obtain a representative test area for the specimen (see 7.2) and for maintenance of reasonable test accuracy. For example, for specimens incorporating air spaces or stud spaces, the metering area shall span an integral number of spaces (see 5.5). The depth of...