. Derive a simple first order system
The system is Oven kitchen Voltage is input.output is Heat or Temperature
Let us assume input voltage=V
Output Heat=H
By Joule's Heating Theorem,
H=I2Rt where I= Current Flow, R= Resistance of the system, & t=time of operation.
By ohm's law V=IR
I=V/R
H=(V/R)2Rt
H=V2t/R
. Derive a simple first order system The system is Oven kitchen Voltage is input.output is...
. Derive a simple first order system The system is Oven kitchen Voltage is input.output is Heat or Temperature
Problem 21–20 pts.: “Kitchen Oven Fiberglass Thickness” • How much fiberglass insulation (k = 0.035 W/m-K) is needed to guarantee that the outer-surface temperature of a kitchen oven will not exceed 43°C? 1 The maximum air temperature of a kitchen oven to be maintained by the conventional type of thermostatic control is 290°C. The kitchen (or room) air temperature may vary from 15°C to 35°C, and the average convection heat transfer coefficient between the oven (inner and outer) surfaces and...
Section I: First Order Systems 1) A microwave oven is used to heat a cylindrical glass beaker completely full of water. The magnetron tube generates 800 watts of thermal power, all of which is absorbed by the water. The glass beaker sits on a thermally insulated plate. As the microwaves increase the temperature of the water, the beaker temperature will also increase due to conduction and convection from the Mode Stirrer Wave Guide Magnetron Tube (source of radiation) Oven Cavity...
a K-type thermocouple is placed in an oven and connected to a computer DAQ system. The junction box temperature is independently measured to be 25 degC. the thermocouple voltage is found to be 35 mV. what is the temperature of the oven?
Single-frequency analysis 2. Derive the 'accurate' amplitude and phase responses of the first-order pole system at the characteristic frequency w1.
(C1HW13) A baking dish is removed from a hot oven and placed on a cooling rack. As the dish cools down to 32.0°C from 168°C, its net radiant power decreases to 11.0 W. What was the net radiant power of the baking dish when it was first removed from the oven? Assume that the temperature in the kitchen remains at 22.0°C as the dish cools.
Signal And System Build a first order LPF with cut-off frequency at 10 kHz. A simple low pass filter (first order) circuit is shown in Figure 1. V = gain 0.7 (a) RC low Pass Filter Circuit Figure 1 (b) Frequency ResponseCurve show that the impulse response for a first order low-pass filter in Figure 1 is given by 1 H(f) = 1+j295RC The cut-off frequency for a low-pass filter is fcutoff ZRC Generate a rectangular pulse with frequency of...
Draw the circuit diagram and derive the frequency transfer function for the first-order passive RL low-pass filter (voltages as input and output). If this filter has a time constant of 2s and the input voltage signal is cos(πt) + sin(3πt) in the time domain, find the output signal in the time domain.
2). Solve the following first order system response to the ramp function (2t) as described in the equation below. (The initial condition is zero). Derive an expression for the steady state error. At what time does it reach 98% of its value? Plot a graph containing the input and system response. 4x + 2x = 21 2). Solve the following first order system response to the ramp function (2t) as described in the equation below. (The initial condition is zero)....
In order for a kitchen appliance to be considered "green" it should draw less than 250 watts. An appliance manufacturer claims to have developed a new "green" toaster oven that consumes an average of no more than 250 W. From previous studies, it is believed that power consumption for toaster ovens is normally distributed with a standard deviation of 18 W. A consumer group suspects the actual average is more than 250 W. They take a sample of 20 toaster...