Specific Heat of Gases/Heat Transfer
Specific Heat of Gases/Heat Transfer One end of rod A is placed in a cold reservoir...
A hot reservoir with a temperature of 687 K is 0.58 m away from a cold reservoir with a temperature of 358 K. The two reservoirs are insulated from each other except for a rod of brass (k = 109 W/m-K) that has a cross-sectional area of 0.058 m2. The entire system is allowed to reach a steady-state condition. 1) How much energy is transferred by heat between the hot reservoir and the cold reservoir in ten minutes? J Submit...
A hot reservoir with a temperature of 687 K is 0.58 m away from a cold reservoir with a temperature of 358 K. The two reservoirs are insulated from each other except for a rod of brass (k = 109 W/m-K) that has a cross-sectional area of 0.058 m2. The entire system is allowed to reach a steady-state condition. 1) How much energy is transferred by heat between the hot reservoir and the cold reservoir in ten minutes? J Submit...
Consider a very long, slender rod. One end of the rod is attached to a base surface maintained at Tb, while the surface of the rod is exposed to an air temperature of 400°C. Thermocouples imbedded in the rod at locations 25 and 120 mm from the base surface register temperatures of 325°C and 375°C, respectively. (a) Calculate the rod base temperature (°C). (b) Determine the rod length (mm) for the case where the ratio of the heat transfer from...
25 PRR HEAT TRANSFER NAME: UNIT SIX AND SEVEN EXCHANGERS BOILING AND CONDENSATION, He- Solve the following problems: 1. In a gas-faired boiler, water is boiler at 150 C by hot gases flowing through 59 m long, 5 cm outer diameter mechanically polished stailess-stell pipes submerged in water, If the outer surface temperature of the pipes is 180 °C. determine (a) the rate of heat transfer from the hot gases to water. (b) the rate of evaporation, (c) the ratio...
Please help with parts a, b, and c
A steel tube (k)of inner and outer diameters D, 24 mm and D, 30 mm, respectively, is used to transfer heat from hot gases flowing over the tube (h 250 ) to cold water flowing through the tube (h 9000) (a) An overall surface efficiency exists for both the hot surface h) and cold surface without any fins on the pipe, what are the values of oh and no.e? (b) Find the...
One end of a long rod 3 cm in diameter is inserted into a furnace with the (3 outer end projecting into the outside air. Once the steady state is reached the temperature of the rod is measured at two points, 15 cm apart and found to be 140°C and 100°C, when the atmospheric air is at 30°C with convection coefficient of 20 W/m2.K. Calculate the thermal conductivity of *.the rod material Consider a stainless steel spoon(k = 15.1 W/m.K), partially...
“A pipe is carrying hot water through a cold storage facility. The ambient air in the cold storage has temperature of ?5?C. To maintain uniform temperature in the cold storage, blowers installed in the facility induce a 3 m/s velocity to the cold air (which can be assumed to be flowing across the water pipe). Hot water inside the pipe has a mean velocity of 0.5 m/s. The internal and exter- nal diameter of the pipe are 8.4 cm and...
CAN YOU PLEASE ANSWER question B
a) A company is redesigning its parallel-flow heat exchanger of length 1 to increase its heat transfer An end view of the unit is shown in the Figure below. There are certain limitations on the design problem. The smallest available conducting tube has a radius of 0.5 cm, and all tubes must be of the same size. Further, the total cross-sectional area of all of the tubes cannot exceed 2000 cm2 to ensure adequate...
A uniform rod (total length L) pivots at one-quarter from one end. It is pulled to one side through a very small angle and allowed to oscillate in a vertical plane. Let the mass m of the rod equal to 1 kg. (a) Determine the period of oscillation T of the physical pendulum if the total length is 2.06 m (4 points). (b) What is the length of a simple pendulum l that has the same period T as found...
Consider a thin rod of length L and mass M
situated with one end at the origin x = 0 of the
coordinate system as shown
Mostly need help with part B. Thank you
a) Four 1 kg boxes sit on a 5 m long uniform rod of mass 4 kg, such that the total mass of the system is 8 kg. The boxes are spaced 1 m apart, with the first box sitting at the left end of the...