Homework Answers
Assuming that the rate of infusion is constant, 1000 mL is to be administered within 10 hours. Thus, the rate of infusion is, 100 mL per hour (1000 mL/100 mL*1 hour)
The designations used in Greenwich Time are, a.m. (morning) and p.m. (afternoon). The military time uses a 24-hour clock system, which is expressed using four digits in terms of “hundred years.” In the military time, the first hour in a day is indicated as 0100 hour, and the end hour as 0200 hour, and the number increases by hindered for each hour.
The volume infused at 0700 hours is, 400 mL. The remaining volume is, 600 mL, which is to be infused over 6 hours. Means, the infusion finish at 1300 hours or 1.00 PM.
Add Answer to:
please
show all work neatly
17. Order: NS 1,000 mL intravenous over 10 h. At 0700h,...
Order: NS 1,000 mL IV stat at 125 mL/h for 8 hours. After 6 hours, 500...
Order: NS 1,000 mL IV stat at 125 mL/h for 8 hours. After 6 hours, 500 mL remain to be infused. The infusion is behind schedule. Compute the new flow rate in mL/h so that the infusion will finish on time. Note that flow rates may not be adjusted by more than 25% of the original rate. To what rate would you reset the drip rate, or would you contact the prescriber?
Order: NS 1,500 mL IV at 125 mL/h for 12 hours. Since the drop factor is 20 gtt/mL, the initial flow rate was correct...
Order: NS 1,500 mL IV at 125 mL/h for 12 hours. Since the drop factor is 20 gtt/mL, the initial flow rate was correctly set at 42 gtt/min. After six hours, 900 mL remain to be infused. The infusion is behind schedule. Compute the new flow rate in gtt/min. so that the infusion will finish on time. If flow rates may not be adjusted by more than 25% of the original rate, to what rate would you reset the drip...
Order DSN 1,000 mLV at 50 ml/h for 20 hours. After 5 hours 700 mL remain...
Order DSN 1,000 mLV at 50 ml/h for 20 hours. After 5 hours 700 mL remain to be infused. The infusion is ahead of schedule. Compute the new flow rate in mL/h so that the infusion will finish on time. Note that now rates may not be adjusted by more than 25% oftn original rate. To what rate would you reset the flow rate, or would you contact the prescriber? O A. Contact the prescriber O B. 40 mlh О...
Order: D5 font size increased by 1 font size increased by 1 ¼ NS 240 ml IV to infuse over 24 hours. Using a micro drop...
Order: D5 font size increased by 1 font size increased by 1 ¼ NS 240 ml IV to infuse over 24 hours. Using a micro drop factor, the initial flow rate was correctly set at 10 mcgtt/min. The client's IV infiltrated and it took 5 hours to restart. After 8 hours 200 ml of IV fluid remains to be infused. The infusion is behind schedule. Compute the new flow rate in mcgtt/min so that the infusion will finish on time....
6) A client is prescribed 500 mL of intravenous fluid in 4 hours. What is the...
6) A client is prescribed 500 mL of intravenous fluid in 4 hours. What is the flow rate of this Infusion in ml/hr? 7) The doctor orders 1000 ML. NS from 6 AM to 6 PM. The IV tubing delivers 15 gtt/mL. Calculate the flow rate for this IV in drops/minute. 7) 8) A doctor orders 500 mg of medication in an IV infusion of 500 mL DSW, 0.006 mg/kg/min. The patient weighs 180 lb. Calculate the flow rate in...
Order: 1,000 ml D5.45 NS at 100 ml/hour to start at 0730. How many hours will...
Order: 1,000 ml D5.45 NS at 100 ml/hour to start at 0730. How many hours will the infusion run? What time does the infusion end? A physician orders heparin 12,500 units in 250 ml D5W to run at 16units/kg/hr for a patient weighing 124 lbs. The nurse should set the infusion pump at ______ml per hour. A physician orders heparin 12,500 units in 500 NS for a patient weighing 132 lbs. Give a bolus of 80 units per kg (heparin...
Please show work so I can understand. 1. A patient with a methicillin resistant Staphylococcus aureus...
Please show work so I can understand.
1. A patient with a methicillin resistant Staphylococcus aureus infection Cipro 400 mg in 200 mL DSW ordered. The pharmacy recommends that the Cipro be infused at a rate of 200 mg/h. What should be the pump rate? 2. Mrs. England has sepsis and has an order for Kefzol 1 Gm in 50 mL of DSWIVPB over 15 minutes. Available tubing has 60 gtts/mL. What should be the infusion rate?
1. Order: methylprednisolone succinate 12 mg IM daily. The package insert of the 40 mg Act-O-Vial...
1. Order: methylprednisolone succinate 12 mg IM daily. The package insert of the 40 mg Act-O-Vial states, " Press down on plastic activator to force accompanying 8 mL diluent into the lower compartment." How many milliliters will you administer per dose? 2.Order: NS 1,000 mL IV stat at 125 mL/h for 8 hours. After 6 hours, 500 mL remain to be infused. The infusion is behind schedule. Compute the new flow rate in mL/h so that the infusion will finish...
1. Order: D5W 500 ml IV infuse over 12 hours. Find the pump setting in ml/hr....
1. Order: D5W 500 ml IV infuse over 12 hours. Find the pump setting in ml/hr. 4 1.6 h 2. Order: NS 1,000 mL IV infuse over 24h. Find the drip rate in drops per minute if the drop factor is 15gtt/mL. 3. A continuous IV is infusing at 120 ml/h. How many milliliters will infuse in two hours and thirty minutes? SOOL 4. An IV starts at 1800 h and runs at 21 gtt/min with a drop factor of...
1. The physician’s order reads: 1.8 L of NS to infuse over 15 hours a. How...
1. The physician’s order reads: 1.8 L of NS to infuse over 15 hours a. How many mL/ h will the IV need to run at in order to deliver the solution as ordered? 2. The physician’s order reads: Give antibiotic in 30 mL D5W over 15 minutes a. How many mL/ h will the IV need to run at in order to deliver the solution as ordered? 3. 1200 mL D5W IV is ordered to infuse in 10 hours...
Order DSN 1,000 mLV at 50 ml/h for 20 hours. After 5 hours 700 mL remain to be infused. The infusion is ahead of schedule. Compute the new flow rate in mL/h so that the infusion will finish on time. Note that now rates may not be adjusted by more than 25% oftn original rate. To what rate would you reset the flow rate, or would you contact the prescriber? O A. Contact the prescriber O B. 40 mlh О...
6) A client is prescribed 500 mL of intravenous fluid in 4 hours. What is the flow rate of this Infusion in ml/hr? 7) The doctor orders 1000 ML. NS from 6 AM to 6 PM. The IV tubing delivers 15 gtt/mL. Calculate the flow rate for this IV in drops/minute. 7) 8) A doctor orders 500 mg of medication in an IV infusion of 500 mL DSW, 0.006 mg/kg/min. The patient weighs 180 lb. Calculate the flow rate in...
Please show work so I can understand.
1. A patient with a methicillin resistant Staphylococcus aureus infection Cipro 400 mg in 200 mL DSW ordered. The pharmacy recommends that the Cipro be infused at a rate of 200 mg/h. What should be the pump rate? 2. Mrs. England has sepsis and has an order for Kefzol 1 Gm in 50 mL of DSWIVPB over 15 minutes. Available tubing has 60 gtts/mL. What should be the infusion rate?
1. Order: D5W 500 ml IV infuse over 12 hours. Find the pump setting in ml/hr. 4 1.6 h 2. Order: NS 1,000 mL IV infuse over 24h. Find the drip rate in drops per minute if the drop factor is 15gtt/mL. 3. A continuous IV is infusing at 120 ml/h. How many milliliters will infuse in two hours and thirty minutes? SOOL 4. An IV starts at 1800 h and runs at 21 gtt/min with a drop factor of...
Most questions answered within 3 hours.
-
Describe the difference between a Change Order (CO), a
Request For Information (RFI), and submittals? Give...
asked 1 minute ago -
A researcher claims that at least 10% of young children suffer
from some food allergy. A...
asked 2 minutes ago -
Help
can you do this?
C programming
Overview
In this program, you will be taking product...
asked 15 minutes ago -
The given plaintext is “Feistel
cipher structure uses the same algorithm for both encryption and
decryption”....
asked 19 minutes ago -
Use the redox table below to answer the following questions.
a) Would MnO2 reduce Cu2+?
b)...
asked 31 minutes ago -
import java.util.Scanner;
public class SieveOfEratosthenes {
public static void main(String args[]) {
Scanner sc...
asked 25 minutes ago -
Given the data below for the reaction, 2 A + 2 B + 4 C =>...
asked 31 minutes ago -
What were the sources of Spanish power in these centuries? Why
was Spain unable to sustain...
asked 33 minutes ago -
How do primary producer, primary consumers, secondary consumers,
and tertiary consumers affect the environment ?
asked 38 minutes ago -
The pet industry has undergone a surge in recent years,
surpassing even the $20 billion a...
asked 47 minutes ago -
what will be a good equation in order to find the
angular torque of the extension...
asked 50 minutes ago -
One of your friends wears glasses with a focal length of 44 cm .
Assume that...
asked 55 minutes ago