ENGR 360/362 Multisim 2 June 17, 2015 DUE JUNE 24, 2015 at 12:00 PM CST (NOON)...
ENGR 360/362 Multisim 2 June 17, 2015 DUE JUNE 24, 2015 at 12:00 PM CST (NOON) Find the answers to the following questions using Multis im. You must find AT LEAST the voltages using multisim. You can use hand calculations for powers, currents, etc. or you can get them from multisim (HINT: I WOULD USE HAND CALCULATIONS AFTER GETTING VOLTAGES FROM MULTISIM). BE CAREFUL ABOUT TAKING CURRENTS DIRECTLY IN MULTISIM BECAUSE THE DIRECTION OF THE CURRENT IS NOT APPARENT. You can use Wattmeters, Voltmeters, and Ammeters with the "flipping the switch" method although I really don't like that route, or you can also perform use AC Analysis or AC Single Frequency Analysis, which is my preferred technique. Don't forget to watch the video on YouTube for assistance. Use Prt Scr to copy your images of circuits and solutions into a word document and submit online in blackboard NOTE: I would NOT use transient analysis to do this (essentially, the flipping the switch is a transient analysis, hence I really don't like it too much for this Also, don't forget Multisim specifies frequency in Hz, not rad/sec. The 3A source is 3A PEAK O degree phase VA 3.6mH VS 1 200 3 A 200 5uF 795.77 Hz 0° 87 C2 20UF VB 40 What are the phasors, Vs, VA, and VB? What are the complex powers absorbed in the 1. 5uF capacitor, the 3.6 mH inductor, and the 40hm resistor? What is the complex power delivered by the source? s
ENGR 360/362 Multisim 2 June 17, 2015 DUE JUNE 24, 2015 at 12:00 PM CST (NOON) Find the answers to the following questions using Multis im. You must find AT LEAST the voltages using multisim. You can use hand calculations for powers, currents, etc. or you can get them from multisim (HINT: I WOULD USE HAND CALCULATIONS AFTER GETTING VOLTAGES FROM MULTISIM). BE CAREFUL ABOUT TAKING CURRENTS DIRECTLY IN MULTISIM BECAUSE THE DIRECTION OF THE CURRENT IS NOT APPARENT. You can use Wattmeters, Voltmeters, and Ammeters with the "flipping the switch" method although I really don't like that route, or you can also perform use AC Analysis or AC Single Frequency Analysis, which is my preferred technique. Don't forget to watch the video on YouTube for assistance. Use Prt Scr to copy your images of circuits and solutions into a word document and submit online in blackboard NOTE: I would NOT use transient analysis to do this (essentially, the flipping the switch is a transient analysis, hence I really don't like it too much for this Also, don't forget Multisim specifies frequency in Hz, not rad/sec. The 3A source is 3A PEAK O degree phase VA 3.6mH VS 1 200 3 A 200 5uF 795.77 Hz 0° 87 C2 20UF VB 40 What are the phasors, Vs, VA, and VB? What are the complex powers absorbed in the 1. 5uF capacitor, the 3.6 mH inductor, and the 40hm resistor? What is the complex power delivered by the source? s