20 points Save Anga LOS (20 pts) Consider the cogeneration plant shown in Figure below Steam...
1. (20 points) Consider a cogeneration system operating at steady state. Superheated steam enters the first turbine stage at 6 MPa, 540 °C. Between the first and second stages, 45% of the steam is extracted at 500 kPa and diverted to a process heating load of 5 x 108 kl/h. Condensate exits the process heat exchanger at 450 kPa with specific enthalpy of 589.13 kl/kg and is mixed with liquid exiting the lower pressure pump at 450 kPa. The entire...
1. (20 points) Consider a cogeneration system operating at steady state. Superheated steam enters the first turbine stage at 6 MPa, 540 °C. Between the first and second stages, 45% of the steam is extracted at 500 kPa and diverted to a process heating load of 5 x 108 kl/h. Condensate exits the process heat exchanger at 450 kPa with specific enthalpy of 589.13 kl/kg and is mixed with liquid exiting the lower pressure pump at 450 kPa. The entire...
10 A cogeneration steam power system is shown below. When maximum process heating is required, the condition is * S (1 Point) Turbine Expansion valve DE Boiler Process heater Condenser 8 Mixing chamber Pump II Pump 1 valve 6 5 Boiler Process heater Condenser 3 8 Mixing chamber Pump II 2 Pump 1 m5 = m6 = 0 m6 = m7 = 0 m7 = 0 None of the above
An industrial steam turbine shown in the figure below receives 20 [kg/s] of superheated steam at 10 [MPa) and 500 [°C] (State 1). Steam is extracted for another industrial process at a rate of 5 kg/s) ata location in the turbine where the pressure is 1 [MPa) and the temperature is 200 [°C] (State 21. The remaining steam continues to expand through the turbine and exit at State 3, where the pressure is 10 [kPa) and the quality is 90%....
A cogeneration plant is similar to a power plant, but some of the thermal energy in the working fluid is used for process heat (for example heating buildings, steel making, or oil refining). An ideal reheat Rankine cycle with regeneration is modified to a cogeneration plant by adding a process heater as shown in the figure below. The process heater acts as a heat removal step where the enthalpy of the steam is reduced by the heat output (qprocess=h7-h3). The...