(12 points) Difficulty (4/5)
a |
b |
c |
h1h1 |
h2h2 |
20 cm |
30 cm |
36 cm |
27 cm |
21 cm |
A folding tray mechanism is attached to a wall as shown. The assembly has the dimensions given above. When a force of F = 175 N is applied at an angle of θθ = 31 degrees, find the internal forces indicated in the table below.
Forces: (Denote rightward or upward forces with positive values; leftward or downward forces with negative values.)
At this |
this |
exerts a |
and a |
on this |
The magnitude |
|
A |
support A |
ABC |
||||
B |
ABC |
BED |
||||
D |
support D |
BED |
||||
E |
EG |
BED |
be sure to include units with your answers
(12 points) Difficulty (4/5) a b c h1h1 h2h2 20 cm 30 cm 36 cm 27...
A folding tray mechanism is attached to a wall as shown. Find the internal forces and bending moment in the lower support arm at section s-s, located midway between points B and E, when a force of F 225 N is applied at an angle of 29 2013 Michael Swanbom BY NC SA Values for dimensions on the figure are given in the following table. Note the figure may not be to scale Variable Value a 21 cm b 28...
(16 points) Difficulty (4/5) A mechanical connection known as a clevis and pin is shown. The dimensions of the assembly are given as: a = 30 mm b = 33 mm c = 10 mm d = 18 mm t = 22 mm W = 45 mm L = 113 mm In order to avoid failure in the materials used to create the parts: -The normal stress in the pin must be limited to 680 MPa. -The shearing stress in...
(1 point) Difficulty (4/5) HOW U EC THEM DOGS? 2013 C@SO Michael Swanbom BY NC SA A truss structure is used to hang signs at an entrance to a stadium. The locations of the centers of gravity of the signs are given by dimensions c and d. Find the forces and stresses carried in the members indicated in the table below, as well as the changes in length of those members. Dimensions, weights, and cross-sectional areas are given below. The...
Problem 17: Four charges of equal magnitude Q = 65 nC are placed on the comers of a rectangle of sides D1 = 15 cm and D2 = 5 cm as shown in the figure. The charges on the left side of the rectangle are positive while the charges on the right side of the rectangle are negative. For this problem, use the coordinate system and angle e indicated in the figure. Part (a) Which choice best represents a free-body diagram...
A. B. C. D. Construct a confidence interval suitable for testing claim that students taking non proctored tests get higher mean score than those taking proctored tests. ___<µ1 - µ2 < ____ Yes/No____ because the confidence interval contains only positive values/only negative values/zero ______. E. Construct a confidence interval suitable for testing claim that students taking non proctored tests get higher mean score than those taking proctored tests. ___<µ1 - µ2 < ____ Yes/No____ because the confidence interval contains only...