The drive roller rotates on a 2.000-inchdiameter shaft on two outboard bearings attached to the frame of the conveyor system. A2-inch shaft extends beyond the bearinga total of 6.00 inchesto allow a drive mechanism. To drive this shaft, a pulley, orsprocket, or gear must be attached to the end of the shaft. Assuming thedrive component (gear, sprocket, or pulley) is permitted a diameter ofno more than15 inchesto allow guarding and clearance.Find all forces, torques,andmoments on the shaft. Designand analyze a square keyto drive the shaftand showa key is or is notsufficient to transmit the torque generated.
We need at least 10 more requests to produce the answer.
0 / 10 have requested this problem solution
The more requests, the faster the answer.
Figure 1 shows the layout of countershaft used to transmit power to a blower through a pulley drive (4-5). Pulley (driving sheave) 4 has a diameter of 125-mm and pulley (driven sheave) 5 has a diameter of 75 mm. Pulley 5 is mounted vertically below pulley 4 (as shown in the figure). Belt tension on the loose side is 20% of the tension on the tight side. A power of 7.5 kW is transmitted via the gear set (2-3) from...
power = 3 kW
if need any more information please ask !!!
You are the designer and you have been asked to design a speed reducer (gearbox) that will take power from the shaft of an electric motor rotating at 1500 rpm and deliver it to a machine that is to operate at approximately at 200 rpm Assume that you have decided to use spur gears to transmit the power [A power equal to the last one digits of your...