3. A PMOS transistor has the gate and drain tied together. The source voltage is V-SV,...
3. For an n-channel MOSFET with gate oxide (SiO2) thickness of 30 nm, threshold voltage of 0.7 V, Z = 30 um, and length of the device is 0.9 μm, calculate the drain current for VG-3 V and VD-0.2 V. Assume that the electron channel mobility is 200 cm'/V-sec. What will be the required drain current to drive the MOS in saturation region? How the drain current will change if HfO2 with Ks 25 will be used as a gate...
3) AMOS Assume a mon I V. 2 V.V2V threshold voltage of 0.7 V. The transistor is in c Sammation ut off d. Not sufficient information since substrate and source are at different voltage levels None of the above 4) Choose the best answer regarding channel length modulation effect Results in lower drain current b. Increases absolute value of the threshold voltage thru body effect Depletion region effectively shortens the channel length d. Makes drain current depend on drain voltage...
Q5. Below figure is a LONG-channel NMOS device biased with two voltage source (Ves and Vos). Assuming this NMOS has a threshold voltage V, of 0.5V, mobility 350cm-NV m, oxide thickness of 10nm, and relative permittivity of 3.9. Calculate the drain current Ing with below bias configurations: (0) Ves = 2V, Vos = 1V, W/L = 4; (ii) Vas = 1V, Vos = 3V, W/L = 2;
A common source amplifier circuit based on a single n-channel MOSFET is shown in Figure 4b. Assume that the transconductance gm-60 mS (equivalent to mA/ V) and drain source resistance, os, is so large it may be neglected. 0) Calculate the open circuit voltage gain Av Yout/ Vis. i) The amplifier has a load of 10 k2. Determine the current gain Va. = 12 V 150k 4k3 Vout Vin 200k GND = 0 V Figure 4b a) State the name...