Since Force Fp is acting at an angle ,we have to split it into its components
Given the surface is frictionless ,so we don't need sine component of force Fp
The force that causes acceleration is cosine component of Force Fp
Net Force =Mass*acceleration
Mass,
ANSWER: Option D.
======================
6:16 LTE a khanacademy.org Forces at an angle A box of mass m is pushed at...
4. A box of mass m 56.0 kg is pushed along a horizontal floor (frictionless floor) a distance d 2.50 m. The constant force exerted on the box makes an angle of 27.0° directed below the horizontal. If the work done by the mover is W 200J, find exerted force? 89.8 N a. b. 549 N 616 N C. d. 176 N?
Question 4 8 pts A box of mass m = 7 kg is being pushed up a ramp that is angled 15 degrees above horizontal. The pushing force P = 49 N. The coefficient of kinetic friction is 0.215. At a certain time the velocity of the box moving up the ramp is 1.0 m/s. How far will the box been pushed during the next 3.0 seconds assuming the same pushing force is applied? In your solution you must show:...
(5 points) A box of mass m is released from rest at the top of a slope of length L at angle θ above the ground. The coefficient of kinetic friction between the box and the slope is μk. (a) (2 points) Draw a figure for the problem, and the free body diagram. and solve for the net forces (b) (1 point) Solve for the net forces along the two axes. (c) (1 point) Solve for acceleration down the slope...
A box of mass m is sliding down an inclined plane. The plane makes an angle ϴ with the horizontal ground. What is the magnitude of the component of the gravitational force that is parallel to the inclined plane? A. m g cosθ B. m g sinϴ C. 0 D. m g If you lift a 2 kg weight through a vertical distance of 1 m at constant velocity, how much work did you do on the weight? Assume the...
Practice problems for forces and motion 1. Refer to the figure below. Let the mass of the block be 9.3 kg and the angle 0 be 60° Frictionless (a) In the figure above, draw a coordinate system that takes advantage of the symmetry of the problem i.e., choose suitable x and y axes) (b) Draw the following vectors in the figure above: The force of gravity acting 1. on the block (with x and y components) 2. The normal force...
Forces and Newton's LAWS WU PHYS 1107 - General Physics I ) An 9.0 kg mass (M) is placed on a horizontal surface. A massless rope runs over a frictionless massless pulley which connects the mass M to a 6.5 kg mass (m) that hangs vertically. a) What is the acceleration of the vertical mass if the horizontal surface is frictionless? b) What is the tension in the rope if the horizontal surface is frictionless? Now assume that the horizontal...
Problem 5: A block with a mass of m=37 kg rests on a frictionless surface and is subject to two forces acting on it. The first force is directed in the negative x-direction with a magnitude of F1=8.5 N. The second has a magnitude of F2 = 19.25 N and acts on the body at an angle θ = 17° measured from horizontal, as shown.Part (a) Please use the interactive area below to draw the Free Body Diagram for this...