Solve all of height h 20 m is constructed ofa vertical wood beams AB of width...
A small dam of height h=2.0 m is constructed of vertical wood beam AB of thickness t=120 mm, as shown in the figure. Consider the beam to be simple supported at the top and bottom. Assuming that the weight density of water is 9.81 kN/m^3. 68.) determine the maximum bending stress in the beams (MPa) 69.) determine the allowable height (in m) of water if the allowable stress of the vertical wood is 1.0 MPa. A small dam of height...
A square wood platform of side-length ? = 2.4 m rests on masonry walls. The deck of the platform is constructed of 4 cm thick planks supported on two beams which are 2.4 m long. The beams have a width of 100 mm and height of 150 mm and are supported at their ends by the walls. The structure is designed to support a uniformly distributed load, ?? (kN/m2), acting over the entire top surface of the platform. The tensile...
Question 2 (25 marks) A square wood platform of side-length L = 2.4 m rests on masonry walls. The deck of the platform is constructed of 4 cm thick planks supported on two beams which are 2.4 m long. The beams have a width of 100 mm and height of 150 mm and are supported at their ends by the walls. The structure is designed to support a uniformly distributed load, wA (kN/m2), acting over the entire top surface of...
A 3 m rigid bar AB is supported with a vertical translational spring at A and a pin at B The bar is subjected to a linearly varying distributed load with maximum intensity g Calculate the vertical deformation of the spring if the spring constant is 700 kN/m. (ans: 21.43 mm) 2. A steel cable with a nominal diameter of 25 mm is used in a construction yard to lift a bridge section weighing 38 kN. The cable has an...
How do I solve this? Problem 2(50 points) The roof of the Edwin A. Stevens building is to be redesigned to accommodate a billboard for Stevens Institute of Technology. The new billboard will weigh 40 kips and be supported equally by two columns located 9 ft from the rear of the building. The beams supporting the new roof will be simply supported as shown. (Note there is a 5 ft overhang at the front of the building). For the grade...