Problems 5.73 The bar AB has a built-in support at A and is loaded by the...
The beam has a fixed support at A and is loaded by two forces and a couple. Draw the free-body diagram of the beam and apply equilibrium to determine the reactions at A 4 kN 2 kN 6 kN-m 60° m++-1.5 m 1.5 m
Statics 5- The beam shown below has an internal hinge at point C. Support A is fixed while support D is a roller. a-Draw the free body diagram for the beam (5 points) b- solve for the reaction forces at support A and D (5 point) Ay (5 points) A- (5 point) Am (5 points) D- SOK 3K/A B 10.17 10 ft 10 ft *
5- The beam shown below has an internal hinge at point C. Support A is fixed while support D is a roller. a-Draw the free body diagram for the beam (5 points) b-solve for the reaction forces at support A and D Ax= (5 point) Ay Dy = (5 points) (5 point) Am = (5 points) 50K 3K/ft B 10 ft 10 ft 10 ft
5) Two rigid members (AE and ABCD) are connected by a pin at A. CK is another rigid bar supported by a fixed-end at K. The contact at C is frictionless and D is and the tension on the cable AH is 52 kN, a roller. If the system is in equilibrium a) draw free body diagrams of all rigid members (AE, ABCD and CK), b) determine P (kN) w (kN/m), all reaction forces (or force components) at A, C,...
PROBLEMS The pin-connected structure is loaded as wn in Figure 5. Bar CD is rigid, and is horizontal before load P is applied. Bar A is made of alumimm 0:- 75 GPa, cross-sectional area-1000 mm2 Bar Bis made of structural steel (E-200 GPa, cross sectional area- 500 20m P150N (a) (15 points) Draw the free body diagram for bar CD, and write down (but do not solve) the equations of static equilibrium for the stracture. (b) (5 points) Is it...
5- The beam shown below has an internal hinge at point C. Support A is fixed while support D is a roller. a-Draw the free body diagram for the beam (5 points) b-solve for the reaction forces at support A and D Ax (5 point) Ay (5 point) Am (5 points) D- (5 points) SOK 3K/ft # B с 10 10 ft 10 ft B ot - inted CORE IS CF-33 A1 A2
Figure Q1(b) shows a beam AD which is loaded with the force F. The coefficient of static friction at the top and bottom surfaces of the wedge are ???=0.25 and ???=0.35, respectively. Neglect the weight, size of the wedge and the thickness of the beam. Considering the value of F from the Table Q1(b) attached, answer the following; (i) Draw the free body diagram of the given problem with all forces and support reactions. (2 marks) (ii) Determine the horizontal...