4. The material used in the transmission gears of an automobile is an injection-molded epoxy containing...
Material Science Help 1. Select the element in the periodic table that is commonly used as an n-type dopant in a silicon semiconductor: a. C b. B c. P d. O 2. The compound with the smallest cation is: a. AuCl b. CaF2 c. ScCl3 d. LiBr 3. The percentage ionic character of MgO is: a. 73 b. 68 c. 81 d. 27 4. The expression for the volume of a unit cell in a BCC crystalline structure is: a....
3. Power transmission is an important engineering application and relies on the integrity of the shaft designs. Assume a solid, circular steel shaft with a uniform diameter d 50 mm and a total length I3 m. At its midpoint, a belt passes over a pulley and delivers 50 kW power to the shaft. This power is used to drive two machines at either end of the shaft. Machine 1 consumes P1 20 kW and machine 2 uses P230 KW. The...
ur thhe spécific for shear, u, and the specific heat of the material. Hence, temperature risc ene machining materials with high strengt cates. The temperature rise at the tool-chip interface is, of course, also a fiu cocfficient of friction. Flank wear (see Section 8.3 and Fig. 8.20a) isction of source of heat, caused by rubbing of the tool on the machined surface. those of the workpiece. generated in the shear plane is a functioll UI material. Hence, temperature rise is...
A 3 m rigid bar AB is supported with a vertical translational spring at A and a pin at B The bar is subjected to a linearly varying distributed load with maximum intensity g Calculate the vertical deformation of the spring if the spring constant is 700 kN/m. (ans: 21.43 mm) 2. A steel cable with a nominal diameter of 25 mm is used in a construction yard to lift a bridge section weighing 38 kN. The cable has an...
Figure 1 shows the layout of countershaft used to transmit power to a blower through a pulley drive (4-5). Pulley (driving sheave) 4 has a diameter of 125-mm and pulley (driven sheave) 5 has a diameter of 75 mm. Pulley 5 is mounted vertically below pulley 4 (as shown in the figure). Belt tension on the loose side is 20% of the tension on the tight side. A power of 7.5 kW is transmitted via the gear set (2-3) from...