complete drawing with section and auxiliary views NOTE: 1. AL DIMENSIONS ARE FROM CASTING PROCESS. 2....

Question

Question

NOTE: 1. AL DIMENSIONS ARE FROM CASTING PROCESS. 2. MAKE FINAL PART WITH EXACT DIMENSIONS AFTER SURFACE FINISH IS PERFORMED.

complete drawing with section and auxiliary views

Answer 1

Answer #1

ANSWER:-

Please find attached all required view & feel free to ask any query.

Please provide positive rating.

30° ISOMETRIC VIEW 12 40 12 36 TOP VIEW 300 64 45 SECTION D-D AUXIALIRY VIEW C FRONT VIEW 75 SIDE VIEW 013-4 HOLE 12

Answer 2

Similar Homework Help Questions

interpreting engineering drawing. I dont need answer 1 port casting bus 12 What is the height...

interpreting engineering drawing. I dont need answer 1 port casting bus 12 What is the height of the shaft support cas machining? QUESTIONS: 1. Calculate distances to 2. How many surfaces require finishing? 3. What tolerance is permitted on dimensions which do not specify a certain tolerance? 4. What type of section view is used on part 17 5. What type of section view is used on part 27 The site of the two holes are to be changed comodate...
Logout Successful dt-content-rid-8312516. 1/courses/20359.201820.11B/182-Hw-8.pdf Department of M...

Logout Successful dt-content-rid-8312516. 1/courses/20359.201820.11B/182-Hw-8.pdf Department of Mechanical Engineering ME 210 - Mechanical Engineering Drawing & Graphies: Term 182 (20 Marks) Problem # 1 Parts of Leveling Device are shown below R20-4 PL 32 2) AUIGNING PLATE MAL IRON-ELEC PLATE-IREG LIFTING WEDGE MAL IRON-ELEC PLATE-1REQ CHROMATE QOZ-325 TYPE 2 CLASS 2-0005 THICK-ALL FILLETSよ ROUNDS RS S AS NOTED 35 THRU 3) SLIDING WEOGE PLATE-IREQ BOTH ENDS MIO x1.5 LH 10 SIDES s) BASE-108 CRS 4 HOLES ELEC PLATE REQ 7 DEEP...