a shaft in hole assembly uses the tolerance symbol of 90H7/s6 for a medium drive fit....
DIMENSION THE HOLES & SHAFTS FOR THE REQUIRED LINEAR TOLERANCE. ALSO, CALCULAGE THE HOLE TOLERANCE, SHAFT TOLERANCE, MAXIMU. CLEARANCE, AND ALLOWANCE DIAMETER: 30 mm TYPE OF FIT: H11/c11 HOLE TOL: SHAFT TOL: MAX. CLEARANCE: ALLOWANCE: DIAMETER: 80 mm TYPE OF FIT: H7/g6 HOLE TOL: SHAFT TOL: MAX. CLEARANCE ALLOWANCE: DIMENSION THE HOLES AND SHAFTS FOR THE REQUIRED LINEAR TOLERANCE, ALSO CALCULATE THE HOLE TOLERANCE, SHAFT TOLERANCE, MAXIMUM CLEARANCE, AND ALLOWANCE 299
Can somone show me how to do the 1st problem? Need to find the LS and SS for the fit and the LH and SH for the hole. Fits are all SHAFT BASIS METRIC but the shaft and hole diameters can not be used right out of the table. This is because the 3mm shaft tolerance does not match. You will need to lookup the "Fit" from the table, and then use the LS (Largest Shaft) and SS (Smallest Shaft)...