We need at least 10 more requests to produce the answer.
0 / 10 have requested this problem solution
The more requests, the faster the answer.
In the figure below, if Rf 470 kohm and Ri 5 kohm, what is the voltage...
1) Calculate the closed-loop voltage gain ACL for the given circuit. 2) Calculate the output voltage Vout in the circuit. (VPP) Required information In the circuit below: Ri = 7.5 k2 and RF = 82 k12. SR = 0.5 V/us Avol = 100,000 RE Zout/OL) = 7502 funity = 1 MHz WW R +15 V 741 + ) Vin = 1 VP-P Vout -15 V
1) Calculate the closed-loop voltage gain ACL for the given circuit. 2) Calculate the output voltage Vout in the circuit. (VPP) Required information In the circuit below: Ri = 7.5 k2 and RF = 82 k12. SR = 0.5 V/us Avol = 100,000 RE Zout/OL) = 7502 funity = 1 MHz WW R +15 V 741 + ) Vin = 1 VP-P Vout -15 V
Be the following active filter: a. Report the value of the cutoff frequency ! with its units, and the value of K. The values of the components are the following: Ri = 1MΩ Rf = 2MΩ C = 1μF b. Graph in detail the Bode diagram of Magnitude on semilogarithmic paper. Rf Ri Vin o ww -o Vout +15V opamp U1 -15V Rf Ri Vin o ww -o Vout +15V opamp U1 -15V
The OpAmp configured below , the voltage gain, A, is given as: A. A = -Rf/R1 B. A = +Rf/R1 C. A =- (R1 +Rf/R1 D. A = 1 + Rf/R1 WW
3. Determine the voltage gain and I/O impedances of the circuits shown in figure below. Assume VA=00. (15 pts) VOD Voo VOD VOD LI M2 M2 M2 M2 R1 RC Rc Vout Vout Vout • Vout Vin 40M Vin 4 M Vin 40M Vin 4M ta a. (3 pts) b. (4 pts) c. (4 pts) d. (4 pts)
Find the voltage gain of the amplifier given below, assuming Rj = 15 kOhm, R2 = 6 kOhm, R, = 2 kOhm, Rx = 17 kOhm, and RL is unknown. Round your answer off to two decimal places. Answer: Check RE Determine the RMS value of the output voltage Vout(t) in units of V, given that R; = 13 kOhms, R1 = 4 kOhms, and that vi(t) = 13 cos(21500t) V. Round your answer off to two decimal places. Answer:...
uestion 3: (10 points) n the RC circuit in the figure, Ri = 10 KQ, R2 = 30 KO, and C 6 uF. aswer the following questions, ) What is the equivalent resistor R12 to R and R2? 2) Find the differential equation relating the output voltage Vout to the input voltage 3) What is the order of the system? 4) What is the time constant t? 5) For step input Vin = 10V, find an expression for the output...
Check point 5: Calculate all voltage drops and currents in this circuit, complete with arrows for current direction and polarity markings for voltage polarity. Then, calculate the overall voltage gain of this amplifier circuit (AV), both as a ratio and as a figure in units of decibels (dB). Find the output voltage and overall voltage gain if R2 changed to 27k12. 22 ko 47 k22 Ri Vout ? Vin = +3.2 volts
In Figure 3 shown, V1 = 100 millivolts. Further, R1 = 1Kohm, R2 = 10 Kohm, R3 = 5 Kohm, R4= 5 Kohm, R5 = 10 Kohm and RL = 1Kohm. (i) Determine the amplified output voltage V2 of the op-amp (of open-loop gain A) in circuit shown in Figure 3. (ii) Suppose this amplified voltage V2 becomes the source voltage to a passive circuit as illustrated in Figure.3. Find Thevenin’s equivalent circuit looking at the terminal XY. Hence, determine...
1. For the following circuits, find the voltage gain, out, and the input and output resistances. VIN IN A R NA Ow+ b PX ON RŞ02 Go, ST VR GT R2322 VIN "Y {R4 vout us VIN 3R4 Vout +0000 $ +00 (h IIN A Rii R2 IN A WWR2 + 01 - + Kvı zi vour un ri 3R3 VOUT iz - 001