Homework Answers
Add Answer to:
Q1: Heated air at 1 atm, 100F, and 23% relative humidity is to be transported in...
Q2. Shell-and-tube heat exchangers with hundreds of tubes housed in a shell are commonly used in...
Q2. Shell-and-tube heat exchangers with hundreds of tubes housed in a shell are commonly used in practice for heat transfer between two fluids (shown in Figure 1). Such a heat exchanger used in an active solar hot-water system transfers heat from a water-antifreeze solution flowing through the shell and the solar collector to fresh water flowing through the tubes at an average temperature of 60°C at a rate of 15 L/S. The heat exchanger contains 80 brass tubes 1 cm...
I hope that the hand writing for the Ans to be clear The Ans should be...
I hope that the hand writing for the Ans to be clear
The Ans should be in details
Heated air at 1 atm, 100 ° F, and 23% relative humidity is to be transported in a 490 ft long circular plastic duct at a rate of 740 cfm (ft 3 /min). If the head loss in the duct is not to À A 11 - Arial (com exceed 790 in. of air, determine the minimum diameter of the duct. (Hint:...
Cooling water available at 680F is flowing through 1 in diameter tube at a rate of...
Cooling water available at 680F is flowing through 1 in diameter tube at a rate of 62000 lb/hr to cool 7000 lb/hr of a lube oil from 200 to 1000F. The specific heat of the lube is 0.62 Btu/lbm oF and viscosity is 5 cp, thermal conductivity is 0.067 Btu/ft-hr °F. The overall heat transfer coefficient is 35 Btu/ft? hr of. It is considered for a single pass exchanger with 44 tubes are requires. a. Draw a schematic diagram of...
Water flowing at a rate of 10 kg/s through 50 tubes in a double-pass shell-and-tube heat...
Water flowing at a rate of 10 kg/s through 50 tubes in a double-pass shell-and-tube heat exchanger heats air which flows on the shell side. The tubes are bras with outside diameter of 2.6 cm and are 6.7m long. The heat transfer coefficients on the inside and outside tube surfaces are 470 W/m2K and 210 W/m2K, respectively. Air enters the unit at 15°C with a flow rate of 16 kg/s. The entering water temperature is 350K. A) Draw and label...
Required information A shell-and-tube heat exchanger is used for cooling 47 kg/s of a process stream...
Required information A shell-and-tube heat exchanger is used for cooling 47 kg/s of a process stream flowing through the tubes from 160°C to 136°C. This heat exchanger has a total of 100 identical tubes. each with an inside diameter of 2.5 cm and negligible wall thickness. The average properties of the process stream are: p = 950 kg/m”, k = 0.50 W/mK, Cp=3.5 kJ/kg.K, and -20 mPas The coolant stream is water (cp=4.18 kJ/kg K) at a flow rate of...
Twenty [kw] of heat is to be removed from 375 [k] water flowing at 0.15 [kg/s] into the inner pipe of concentric tube heat exchanger. Cooling water enters the annulus at 290 [k] and leaves at 320...
Twenty [kw] of heat is to be removed from 375 [k] water flowing at 0.15 [kg/s] into the inner pipe of concentric tube heat exchanger. Cooling water enters the annulus at 290 [k] and leaves at 320 [k] with a flow in the opposite direction of the inner flow. The diameter of the thin- walled inner pipe is 2.5 [cm] a) b) c) Calculate the exit temperature of the hot fluid and the mass flow rate of the cold fluid...
12.54 Air at 12°C, 1 atm, and 40% relative humidity enters a heat exchanger with a...
12.54 Air at 12°C, 1 atm, and 40% relative humidity enters a heat exchanger with a volumetric flow rate of 1 m'/s. A separate stream of dry air enters at 280°C, 1 atm with a mass flow rate of 0.875 kg/s and exits at 220°C. Neglecting heat transfer between the heat exchanger and its surroundings, pressure drops of ach stream, and kinetic and potential energy effects, determine (a) the temperature of the exiting moist air, in °C
Air enters a 23-cm-diameter 13-m-long underwater duct at 53°C and 1 atm at a mean velocity...
Air enters a 23-cm-diameter 13-m-long underwater duct at 53°C and 1 atm at a mean velocity of 7 m/s, and is cooled by the water outside. If the average heat transfer coefficient is 85 W/m2 °C and the tube temperature is nearly equal to the water temperature of 5°C, determine the exit temperature of air and the rate of heat transfer. Use Table A-15 for the properties of air at the anticipated average temperature of 30°C. Answer in Watts. please...
QUESTION 4 (25 marks) Water (Cr 4.208 kJ/kg.K) at flow rate of 5.11 kg/s s heated from 78°C to 98°C in an economize...
QUESTION 4 (25 marks) Water (Cr 4.208 kJ/kg.K) at flow rate of 5.11 kg/s s heated from 78°C to 98°C in an economizer inside a boiler. The boiler is a cross flow heat exchanger with single pass, shell fluid mixed and other fluid unmixed. The average water velocity in the 1.5 cm diameter (D) tube is 1.27 m/s. On the shell side, hot air (C,-1.0341 kJ/kgK) was used as the heating fluid with 7.3 kg/s of it entering the exchanger...
please show all steps and do both. if you dont do both problems please do problem...
please show all steps and do both. if you dont do both
problems please do problem 2 is more important .
Problem 2. (45 Points) Cooling water available at 680F is flowing through 1 in diameter tube at a rate of 62000 lb/hr to cool 7000 lb/hr of a lube oil from 200 to 1000F. The specific heat of the lube is 0.62 Btu/lbm oF and viscosity is 5 cp, thermal conductivity is 0.067 Btu/ft-hr °F. The overall heat transfer...
Q2. Shell-and-tube heat exchangers with hundreds of tubes housed in a shell are commonly used in practice for heat transfer between two fluids (shown in Figure 1). Such a heat exchanger used in an active solar hot-water system transfers heat from a water-antifreeze solution flowing through the shell and the solar collector to fresh water flowing through the tubes at an average temperature of 60°C at a rate of 15 L/S. The heat exchanger contains 80 brass tubes 1 cm...
I hope that the hand writing for the Ans to be clear
The Ans should be in details
Heated air at 1 atm, 100 ° F, and 23% relative humidity is to be transported in a 490 ft long circular plastic duct at a rate of 740 cfm (ft 3 /min). If the head loss in the duct is not to À A 11 - Arial (com exceed 790 in. of air, determine the minimum diameter of the duct. (Hint:...
Cooling water available at 680F is flowing through 1 in diameter tube at a rate of 62000 lb/hr to cool 7000 lb/hr of a lube oil from 200 to 1000F. The specific heat of the lube is 0.62 Btu/lbm oF and viscosity is 5 cp, thermal conductivity is 0.067 Btu/ft-hr °F. The overall heat transfer coefficient is 35 Btu/ft? hr of. It is considered for a single pass exchanger with 44 tubes are requires. a. Draw a schematic diagram of...
Water flowing at a rate of 10 kg/s through 50 tubes in a double-pass shell-and-tube heat exchanger heats air which flows on the shell side. The tubes are bras with outside diameter of 2.6 cm and are 6.7m long. The heat transfer coefficients on the inside and outside tube surfaces are 470 W/m2K and 210 W/m2K, respectively. Air enters the unit at 15°C with a flow rate of 16 kg/s. The entering water temperature is 350K. A) Draw and label...
Required information A shell-and-tube heat exchanger is used for cooling 47 kg/s of a process stream flowing through the tubes from 160°C to 136°C. This heat exchanger has a total of 100 identical tubes. each with an inside diameter of 2.5 cm and negligible wall thickness. The average properties of the process stream are: p = 950 kg/m”, k = 0.50 W/mK, Cp=3.5 kJ/kg.K, and -20 mPas The coolant stream is water (cp=4.18 kJ/kg K) at a flow rate of...
Twenty [kw] of heat is to be removed from 375 [k] water flowing at 0.15 [kg/s] into the inner pipe of concentric tube heat exchanger. Cooling water enters the annulus at 290 [k] and leaves at 320 [k] with a flow in the opposite direction of the inner flow. The diameter of the thin- walled inner pipe is 2.5 [cm] a) b) c) Calculate the exit temperature of the hot fluid and the mass flow rate of the cold fluid...
12.54 Air at 12°C, 1 atm, and 40% relative humidity enters a heat exchanger with a volumetric flow rate of 1 m'/s. A separate stream of dry air enters at 280°C, 1 atm with a mass flow rate of 0.875 kg/s and exits at 220°C. Neglecting heat transfer between the heat exchanger and its surroundings, pressure drops of ach stream, and kinetic and potential energy effects, determine (a) the temperature of the exiting moist air, in °C
QUESTION 4 (25 marks) Water (Cr 4.208 kJ/kg.K) at flow rate of 5.11 kg/s s heated from 78°C to 98°C in an economizer inside a boiler. The boiler is a cross flow heat exchanger with single pass, shell fluid mixed and other fluid unmixed. The average water velocity in the 1.5 cm diameter (D) tube is 1.27 m/s. On the shell side, hot air (C,-1.0341 kJ/kgK) was used as the heating fluid with 7.3 kg/s of it entering the exchanger...
please show all steps and do both. if you dont do both
problems please do problem 2 is more important .
Problem 2. (45 Points) Cooling water available at 680F is flowing through 1 in diameter tube at a rate of 62000 lb/hr to cool 7000 lb/hr of a lube oil from 200 to 1000F. The specific heat of the lube is 0.62 Btu/lbm oF and viscosity is 5 cp, thermal conductivity is 0.067 Btu/ft-hr °F. The overall heat transfer...
Most questions answered within 3 hours.
-
Cisco packet tracer
Q1) Do you get any changes of IP address when packet is
traversing...
asked 15 minutes ago -
What is the pressure inside a 33.0 L container holding 106.4 kg
of argon gas at...
asked 1 hour ago -
Question no 2
A housekeeping support department budgets its costs at
SR 40,000 per month plus...
asked 1 hour ago -
A 1400Kg sports car accelerates from rest to 90km/h in 7.0s.
What is the average power...
asked 1 hour ago -
For the following reaction, 0.128 moles of
potassium hydrogen sulfateare mixed with
0.504 moles of potassium...
asked 5 hours ago -
1. What is the present value of $400, three years in the future
if the interest...
asked 5 hours ago -
The labor force minus the number of employed equals the number
of unemployed.
a. True
b....
asked 7 hours ago -
Determine the mass in units of grams [g] of 0.49 moles [mol]
of a new fictitious...
asked 8 hours ago -
A horizontal mass of M=5kg is on a spring and stretched to
x=0.5m when released from...
asked 9 hours ago -
26 of 50
"I have worked at the Arizona Humane Society for ten years, and
have...
asked 9 hours ago -
Compare and contrast zero based budgeting and incremental (or
base year) budgeting.
asked 9 hours ago -
4 pts 10. Which of the following hypothesis would be MOST
difficult to test experimentally? Group...
asked 9 hours ago