What are systematic and statistical possible sources of error when using a multimeter? (when measuring resistance in a circuit)
The main sources of systematic error
1.effect of environmental disturbances, often called modifying inputs
2.disturbance of the measured system by the act of measurement
3.changes in characteristics due to wear in instrument components over a period of time
4.resistance of connecting leads
The main sources of statistical error
1.sampling
2. measurement
3. estimation
4 hypothesis testing
5. reporting.
What are systematic and statistical possible sources of error when using a multimeter? (when measuring resistance...
1. How is the multimeter connected to the circuit when measuring current? a In parallel. b It doesn’t matter. c In series. d It depends on the multimeter.
Prob. 2 (5pts) A multimeter on the 30 DC volt scale has an input resistance of 10 megaohms. If the multimeter is used to measure the potential drop across R2 in the following circuit, what is the error in the multimeter reading? R110 Mohms R2 5 Mohms
Which method of measuring current is more accurate direct or indirect method? Direct: using multimeter Indirect: Ohms Law Which disturbs the circuit operation and should be avoided?
What are some possible sources of error that would lead to a low yield in the synthesis of methyl benzoate from benzoic acid and methanol with sulfuric acid using Fischer Esterification.
List three sources of error you expected to encounter in measuring molar mass of a volatil compound experiment and describe how this method is designed (or could be better designed) to minimize tge listed error sources?
Discuss possible sources of error in this experiment. How would these sources of error affect your calculated value of N? Write out your answer in a clear and well supported paragraph.
what are the possible Sources of error in the Preparation of cyclohexene from cyclohexanol experiment?
Question 1: multimeter sampling when measuring voltage from a function generator A. How often do you think the meter samples? B. What do you thinking the steps are for the meter to take a sample, convert it into numerical measurement and display it on the screen?
Systematic sources of errors for using stopped-flow spectrophotometry technique?
We have already noted two sources of systematic error in the use of this method: not enough sample to displace all the air from the flask and the finite vapor pressure of the unknown. Consider the following possible errors. For each one, describe how the results might be impacted. Please try to be specific (e.g. "The molar mass will be overestimated because...") a. The volume of your flask was found by weighing it, filled with water, at room temperature (20°C)....