3. A 33-KW motor, using a set of gears, drives a shaft at a speed n,...
3. A 33-kW motor, using a set of gears, drives a shaft at a speed n, as illustredted in Fig. P3, with a safety factor = 2.2 what will be the total angle of twist between A and B. Given: G = 82 GPa, Typ = 210 MPa, n = 1500 rpm? (a) 16.64°, (b) 18.64°, (c) 14.64°9, (d) 10.64", (e) none of above 2 m 5 m A с C B Motor 8 kW off 25 kW off 33...
D is incorrect, already tried 3. A 33-KW motor, using a set of gears, drives a shaft at a speed n, as illustredted in Fig. P3, with a safety factor = 2.2 what will be the total angle of twist between A and B. Given: G = 82 GPa, Typ = 210 MPa, n = 1500 rpm? (a) 16.64', (b) 18.64", (c) 14.64°9, (d) 10.64", (e) none of above 2 m 5 m с Motor 25 kW 8 kW off...
The input power of shaft ABC at A is P = 8 kW, at rotation of 600 rpm. The shaft DEF is free rotate. Material for the shafts are Ck22 with ay 360 MPa; συ-550 MPa; E-210 Gpa; G-77 GPa. Determine . Diameter shaft ABC and DEF with safety factor Sr 2.0 and τ.-0.4 Round-up to the nearest even number. 150 mm 300 um Supposed shaft DEF is fixed at F, determine: Angle of twist shaft DEF 200 m 150...
3. (30 pts) A shaft is driven at A by a motor that transmits 5 kW to the shaft at 10 112. The gears Band C drive machinery require power equal to 3.5 KW and 1.5 kW respectively. The material of the shall has shear modulus G - 75 GPa Two cross-section contigurations are considered as shown all of them have about same cross-section areas) d-20 mm t=3 mm, a=17.5 mm a) What is the maximum torque on the shaft...
Desgin 0.2) Figure Q.2 shows a drive system in which a 20-hp electric motor drives separate output shafts. Gear A is mounted on the motor shafit that has a rotational spoed or 1750 rpm clockwise. Gear A drives gear train consisting of…B,C,and D thr deliver power through the shafts on which they are mounted. All gears have a diametral pitch of Pa-8.The following data are given Power delivered by gears B, C, and D: Pa Numbers of teeth for all...
power = 3 kW if need any more information please ask !!! You are the designer and you have been asked to design a speed reducer (gearbox) that will take power from the shaft of an electric motor rotating at 1500 rpm and deliver it to a machine that is to operate at approximately at 200 rpm Assume that you have decided to use spur gears to transmit the power [A power equal to the last one digits of your...