please explain clearly
thanks....
Answer. Double shear
Remark: The bolt has covered both I section flange and the bracket of applied force, failure can occur from any of these side in the bolt therefore it is a double shear case.
please explain clearly thanks.... The figure shows and example of: Р Single shear Double Shear
Question 4 The figure shows and example of: P Single shear Double Shear
> Question 4 5 pts The figure shows and example of: с E E' D Single shear Double Shear Question 5 5 pts Considering the figure below, which curve shows the brittle material? stress MacBook Air DOO DOO F4 1 - $ 4 % 5 & 7 I 6 8 9 R T Y U -
The figure shows and example of: C F E А B E' F D O Single shear O Double Shear
I believe D is a double Shear and B is single shear Rigid beam ABC is supported by a pin support at A and axial member (1). Member (1) is connected by two different pin conditions as shown in the figure and it has a diameter of 3". Each pin has a diameter of 1.5 a) Calculate the internal force in member (1) in kips and clearly indicate Tension (T) or 2) Compression (C). [Ans. to Check: 62.5 k b)...
The figure below shows the flow curve for FCC single crystal material: 3. Stage 3 Stage 2 Stage 1 3 2 1 Stage 0 Resolved shear strain Resolved shear stress (MPa) A. Explain the stages in this curve. B. Which stage can be described by the TEM image in this figure? C. If the yield strength was 4 MPa, calculate the orientation factor of this crystal. The figure below shows the flow curve for FCC single crystal material: 3. Stage...
Could you please explain the answer of this question clearly? Thanks in Advance, "will rate up the coreect and detailed explaination"
anyone could explain this matlab code step by step and clearly?? thanks in advance! figure; m = complexmat(1000, -0.7+0.7i, -0.5 + 0.6i); v = arrayfun(@(x) converge(x), m); image(v);
In the figure, the rigid member ABDE is supported at A by a single shear pin connection and at B by a tie rod (1). The tie rod is attached at B and C with double shear pin connections. The pins at A, B, and C each have an ultimate shear strength of 84 ksi, and tie rod (1) has a yield strength of 63 ksi. A concentrated load of P = 20 kips is applied perpendicular to DE, as...
Please clearly and legibly label the answer in each part, and explain thoroughly. Thanks in advance Design a synthesis to achieve each of these in two or more steps. steps steps N Suggest a mechanism for this transformation. H Ph. H2N. -NH N Ph
please explain the ans clearly, thanks (a) Are the following statements true or false? Briefly explain your answer. i) “The duration of a zero-coupon bond equals its time to maturity.” ii) Holding maturity constant, a bond's duration is lower when the coupon rate is higher.” iii) “Holding other factors constant, the duration of a coupon bond is higher when the bond's yield to maturity is lower.” (12 marks) (b) “It is not possible to forecast stock returns in an efficient...