4.45 A Laval nozzle of area ratio 1.4 operating in an underexpanded condition exhibits a wave...
A converging-diverging nozzle has a throat area of 1 cm2 and an exit area of 4 cm2. The inlet stagnation conditions are Po 500 kPa and To 300 K. The nozzle discharges to an infinite surroundings at Po. The flowing medium is air as a perfect gas with k-1.4 Answer the following: i What are the two isentropic flow solutions for this nozzle with M 1 at the throat? What are the Mach number, P, Po and T, To at...
GAS DYNAMICS 3 M = 2.2 M, = 22 124 12 (a) (b) Figure 4.55 (a) One-shock spike, (b) two-shock spike diffuser. Figure 4.56 Supersonic flow past a sharp corner. M OM P12 м. 10° Figure 4.57 Flow through incident and reflected oblique shocks. M = 2.4 P1 = 101 kPa 10° Oblique Shock and Expansion Waves 219 Figure 4.58 Oblique shock reflection from a solid wall. M,=2.2 Po= 100 kPa M2 M 30° Air X Jet boundary Figure 4.59...
Question 4 Soalan 4] (a) A supersonic nozzle is attached to a constant diameter circular duct at its exit The duct diameter is the same as the nozzle exit diameter. Nozzle exit cross- section area is three times that of its throat. The gas (k1.4, R = 287 J/kg-K ) enters the nozzle with pressure and temperature of 10 bar and 600 K respectively with negligible velocity. If a normal shock occurs at a section in the diverging part of...
2. An aircraft with a single turbojet engine (with an inlet area of 1 m2) is flying at cruising condition with a flight Mach number of 0.7. The ambient temperature and pressure are 250 K and 100 kPa, respectively. The engine compressor pressure ratio is 12, and the turbine inlet temperature is 1200 K. Assume all mechanical components are operating at isentropic condition and the specific heat can be considered a constant (throughout the entire engine) of 1 kJ/(kg K)....
(a) A supersonic nozzle is attached to a constant diameter circular duct at its exit The duct diameter is the same as the nozzle exit diameter. Nozzle exit cross section area is three times that of its throat. The gas (k-14, R 287 Jg K) enters the nozzle with pressure and temperature of 10 bar and 600 Krespectively with negligible velocity. If a normal shock occurs at a section in the diverging part of the nozzle where the area ratio...