Homework Answers
Add Answer to:
A pump that is 80% efficient pumps water from the lower tank to the upper tank...
A pump transports water from Tank 1 to Tank 2 through a constant-diameter piping system as...
A pump transports water from Tank 1 to Tank 2 through a constant-diameter piping system as shown below (not to scale). The flow rate is controlled by two gate valves, the gate valve I controls the main pipeline, while the gate valve II controls the loop line from T-joint A to T-joint B. All pipes are galvanized steel pipe of diameter D = 4 in. It has a total length of Li2= 620 ft from tank 1 to tank 2....
A pump carries water at a temperature of 30 ° C from one tank (A) to...
A pump carries water at a temperature of 30 ° C from one tank
(A) to another (B). The diameter of the pipe leaving tank A and
reaching the pump is 4 inches. The diameter of the pipe leaving the
pump and reaching tank B is 3 inches. The pump motor increases the
fluid pressure by 3 kgf / cm2 (ΔP), and generates a power per unit
of mass of 300 J / kg. Calculate the height difference (ΔZ) between...
1 A pump delivers water from the lower reservoir to the upper reservoir at a rate of 60 L/s. Both...
1 A pump delivers water from the lower reservoir to the upper reservoir at a rate of 60 L/s. Both the suction and discharge pipes are DN 150 schedule 40steel pipe. The length of the suction pipe leading to the pump is 3.5 m, and 7 m of discharge pipe extend from the pump outlet to the upper tank. There are three standard 900 elbows and a fully open gate valve. The depth of the fluid level inside the lower...
A turbo pump transfers water from tank 1 to tank to tank 2 as shown in...
A turbo pump transfers water from tank 1 to tank to tank 2 as
shown in the picture below. The diameter of the piping system is D=
4in and the total length of pipes is L=620 ft. the elevation
difference is Z1-Z2= 30ft. Use the chart for KL values.
a) determine the flow rate (Q)
b) power of the pump in HP
Note that you can write out both mass balance equation and energy equation of the head form for...
A turbo pump transfers water from tank 1 to tank to tank 2 as shown in...
A turbo pump transfers water from tank 1 to tank to tank 2 as
shown in the picture below. The diameter of the piping system is D=
4in and the total length of pipes is L=620 ft. the elevation
difference is Z1-Z2= 30ft. Use the chart for KL values.
a) determine the flow rate (Q)
b) power of the pump in HP
Note that you can write out both mass balance equation and energy equation of the head form for...
Water (density 998 kg/mº, dynamic viscosity 0.001 Pa s) is pumped between two reservoirs at a...
Water (density 998 kg/mº, dynamic viscosity 0.001 Pa s) is pumped between two reservoirs at a volumetric flow rate of 0.006 m/s through a 120-m long pipe of 5 cm diameter. The roughness ratio of the pipe is a/d = 0.001. There are some fittings and valves in the pipe system, as shown in Figure Q1. The loss coefficients of the valves and fittings can be found in Table Q1. The Darcy friction factor can be found in the Moody...
The Water at pipe discharges above a tank on the mountain at an elevation that is...
The Water at pipe discharges above a tank on the mountain at an elevation that is 60°F is pumped from a reservoir at sea level to the top of a 4000 ft above the e pipeline itself consists of schedule 80, wrought iron/steel pipe. The pipe is 5" (sch 80) section of pipe is 5000 ft long containing 20 standard 90° elbows and 20 standard 45° elbows. If you have a 20,000 hp pump and motor that is driving it...
A centrifugal pump takes water from the bottom of a supply tank and delivers it into...
A centrifugal pump takes water from the bottom of a supply tank and delivers it into the bottom of another tank. The water level in the discharge tank is 50m above the level in the supply tank. The line between the tanks is 200m of 4-in commercial steel pipe. The ow rate is 1200 l/min. In the line, there two gate valves, four standard tees and four elbows. What is the energy cost of the running this pump for one...
1. A pump steadily delivers 13.7 kg/s of water at the conditions given below. Calculate the...
1. A pump steadily delivers 13.7 kg/s of water at the conditions given below. Calculate the pump power (hp). There is no heat transfer from the pump to the surroundings (i.e., adiabatic conditions). Pump Inlet Temperature = 20oC Pump Inlet Pressure = 182 kPa Pump Inlet Diameter = 11.1 cm Pump Inlet Elevation = 20 m Pump Exit Temperature = 20oC Pump Exit Pressure = 601 kPa Pump Exit Diameter = 7.8 cm Pump Exit Elevation = 20 m Answer...
A pump transmits water at 10 °C from the reservoir to an elevated tank L2= 150...
A pump transmits water at 10 °C from the reservoir to an elevated tank L2= 150 m as shown. The loss coefficient in Elevation = 190 m Elevation = 185 m each bend is 0.4 and loss in the pipe Water entrance is Ke = 0.5. There are no L=100 m loss at the pipe exit at the elevated Elevation D -20 cm tank. The pipelines are made of steel. -150 m -- Elevation - 145 m State your assumptions...
A pump transports water from Tank 1 to Tank 2 through a constant-diameter piping system as shown below (not to scale). The flow rate is controlled by two gate valves, the gate valve I controls the main pipeline, while the gate valve II controls the loop line from T-joint A to T-joint B. All pipes are galvanized steel pipe of diameter D = 4 in. It has a total length of Li2= 620 ft from tank 1 to tank 2....
A pump carries water at a temperature of 30 ° C from one tank
(A) to another (B). The diameter of the pipe leaving tank A and
reaching the pump is 4 inches. The diameter of the pipe leaving the
pump and reaching tank B is 3 inches. The pump motor increases the
fluid pressure by 3 kgf / cm2 (ΔP), and generates a power per unit
of mass of 300 J / kg. Calculate the height difference (ΔZ) between...
1 A pump delivers water from the lower reservoir to the upper reservoir at a rate of 60 L/s. Both the suction and discharge pipes are DN 150 schedule 40steel pipe. The length of the suction pipe leading to the pump is 3.5 m, and 7 m of discharge pipe extend from the pump outlet to the upper tank. There are three standard 900 elbows and a fully open gate valve. The depth of the fluid level inside the lower...
A turbo pump transfers water from tank 1 to tank to tank 2 as
shown in the picture below. The diameter of the piping system is D=
4in and the total length of pipes is L=620 ft. the elevation
difference is Z1-Z2= 30ft. Use the chart for KL values.
a) determine the flow rate (Q)
b) power of the pump in HP
Note that you can write out both mass balance equation and energy equation of the head form for...
A turbo pump transfers water from tank 1 to tank to tank 2 as
shown in the picture below. The diameter of the piping system is D=
4in and the total length of pipes is L=620 ft. the elevation
difference is Z1-Z2= 30ft. Use the chart for KL values.
a) determine the flow rate (Q)
b) power of the pump in HP
Note that you can write out both mass balance equation and energy equation of the head form for...
Water (density 998 kg/mº, dynamic viscosity 0.001 Pa s) is pumped between two reservoirs at a volumetric flow rate of 0.006 m/s through a 120-m long pipe of 5 cm diameter. The roughness ratio of the pipe is a/d = 0.001. There are some fittings and valves in the pipe system, as shown in Figure Q1. The loss coefficients of the valves and fittings can be found in Table Q1. The Darcy friction factor can be found in the Moody...
The Water at pipe discharges above a tank on the mountain at an elevation that is 60°F is pumped from a reservoir at sea level to the top of a 4000 ft above the e pipeline itself consists of schedule 80, wrought iron/steel pipe. The pipe is 5" (sch 80) section of pipe is 5000 ft long containing 20 standard 90° elbows and 20 standard 45° elbows. If you have a 20,000 hp pump and motor that is driving it...
A pump transmits water at 10 °C from the reservoir to an elevated tank L2= 150 m as shown. The loss coefficient in Elevation = 190 m Elevation = 185 m each bend is 0.4 and loss in the pipe Water entrance is Ke = 0.5. There are no L=100 m loss at the pipe exit at the elevated Elevation D -20 cm tank. The pipelines are made of steel. -150 m -- Elevation - 145 m State your assumptions...
Most questions answered within 3 hours.
-
Gustin Corp manufactures, sells, and leases medical equipment.
Gustin Corp agrees to lease 3 CAT scanners,...
asked 2 minutes ago -
Describe the origin of the cardiac contraction signal and the
pathway it follows through the heart.
asked 11 minutes ago -
Consider the following data:
x
−6−6
−5−5
−4−4
−3−3
−2−2
P(X=x)P(X=x)
0.20.2
0.20.2
0.20.2
0.20.2
0.20.2...
asked 10 minutes ago -
Find the area under the standard normal curve to the left of
z
= -1.22 ....
asked 21 minutes ago -
an afro-carribean family is seeking psychotherapeutic help
because they are concerned about their son, Trevor, is...
asked 22 minutes ago -
In Wealth of Nations, how does Smith introduce the reader to the
central concept of the...
asked 24 minutes ago -
Assess the Strategy-Evaluation Framework, including reviewing
bases of strategy, measuring organizational performance, and taking
corrective actions....
asked 28 minutes ago -
The International Nanny Association (INA) reports that in a
sample of 928 in- home child care...
asked 28 minutes ago -
13. David and Julie have two children, ages 18 and 10. Their
modified AGI is $120,000....
asked 47 minutes ago -
Can you fix my error?
I created a program that changes labels every second in
Java....
asked 43 minutes ago -
Suppose a monopolist has the demand function Q = 1000P^-3. Use
the Lerner Index to find...
asked 45 minutes ago -
You hypothesize that students in fraternities/sororities on your
campus are more extroverted (on an introversion/extroversion scale)...
asked 1 hour ago