(c) The outer diameter and thickness of an air compressor tank are 25 in. and 0.25...
Question 4. (c) The outer diameter and thickness of an air compressor tank are 25 in. and 0.25 in., respectively. If the compressor tank pressure reached 120 psi, determine the hoop and longitudinal stresses acting at point B. (15 points)
Question 4. (c) The outer diameter and thickness of an air compressor tank are 25 in. and 0.25 in., respectively. If the compressor tank pressure reached 120 psi, determine the hoop and longitudinal stresses acting at point B. (15 points) B
Question 4. (C) The outer diameter and thickness of an air compressor tank are 25 in. and 0.25 in., respectively. If the compressor tank pressure reached 120 psi, determine the hoop and longitudinal stresses acting at point B. (15 points) .B
Mechanics and Material Help Question 4. (e) The outer diameter and thickness of an air compressor tank are 25 in and 0.25 in., respectively. If the compressor tank pressure reached 120 psi, determine the hoop and longitudinal stresses acting at point B. (15 points) .B
Applied Mechanics of Materials. Need Help (c) The outer diameter and thickness of an air compressor tank are 25 in. and 0.25 in., respectively. If the compressor tank pressure reached 120 psi, determine the hoop an longitudinal stresses acting at point B. (1 .B
Part A The tank of the air compressor subjected to an internal pressure of 96 psi . The internal diameter of the tank is 22 in., and the wall thickness is 0.25 in. (Figure 1) Determine the hoop stress acting at point A. Express your answer to three significant figures and include the appropriate units. Li HA ? 0,= Value Units Submit Request Answer Figure Part B 1 of 1 Determine the longitudinal stress acting at point A. Express your...
SIT 3. A compressed-air tank is supported by two cradles as shown. One of the cradles is designed so that it does not exert any longitudinal force on the tank. The cylindrical body of the tank has a 30-in. outer diameter and is made of a 3/8-in. steel plate by butt welding. The end caps are spherical and have a uniform wall thickness of 5/16 in. For an internal gage pressure of 180 psi, determine: 4. Then longitudinal stress in...
A cylindrical pressure vessel of 250 mm mean diameter and 6 mm wall thickness is fabricated from a 1.2 m length of spirally welded pipe AB as shown. Tank gauge pressure is 4 MPa and centric axial forces P and P1 of 240 kN act through rigid end plates. Determine: (a) Net longitudinal and hoop stresses. (b) Normal stress acting perpendicular to weld and shear stress parallel to weld (show sketch of Mohr’s circle). (c) Determine the Factor of Safety...
A 50 inch diameter steel pipe with a thickness of 0.25 inches, carries oil of specific gravity of 0.822 under a head of 350 ft of oil. Compute the pressure inside the pipe in psi, circumferential stress, Compute the thickness of steel required to carry a pressure of 220 psi with a hoop stress of 18,000 psi.
A pressure vessel of 12” outer diameter and 0.2” wall thickness is fabricated by welding plate in spiral into a cylinder that is 4 feet long. The gage pressure inside the vessel is 800 psi and 15 kip axial compression forces are applied to the rigid end caps. Determine the a) the principle stresses in the walls of the vessel, b) the maximum shear stress in the wall of the vessel (in or out of plane), c) the stress normal...