Q2: For the circuit shown below, Vs1 is 17.268 volt and Vs2 is 21.097 volt. What...
Q1: For the circuit shown below, Vs(t)=18.965cos(1200rt) vollt. What is the peak value of Vo? Vpst Vs 09 Vps - RL Vo QUESTION 2 Q2: For the circuit shown below. Vs1 is 12.168 volt and Vs2 is 29.305 volt. What is the value of Vo? Ri=10K W Rp=10K w +15 R2-20K 2 6 + Vs2 13+ - 15 10K VE Rx=3.3K
In the circuit shown in the figure below, if vS1 = vS2 = 15 mV, RF = 3.6 kΩ , R1 = 330 Ω, R2 = 560 Ω , and RL = 10 kΩ , determine the output voltage, vo (in mV). (Enter your answer as a number without the units.)
vs1 is 15 vs2 is 6 Is 4.5 3. For the circuit shown: (a) Write all required equations to solve the circuit shown using Nodal Analysis. (b) Solve these equations to find all nodal voltages. (c) Find L. Vs. 1y. Vy, and Vs. (40) . V 1092 + Vs2 1 Vsi. Vs: & I are in the Table
Q2. For the op-amp circuit as shown below, given that RS = 49.5 k, RL = 12 k 2, R1 = 10 kO, R2 = 9 ㏀, R3 = 7.5 ko, R4 = 5 ㏀R5 = 2.2 k2 Ry vo Ry Ri Rs (a) Determine the voltage gain G1-vo1/vs: Submit Answer Tries o/5 (b) Determine the voltage gain G2-vo/vs: Submit Answer Tries o/5 Q3. For the op-amp circuit shown below, find the value of VO, where R1 = 20 Ω,...
R2 R, Q2. In the above circuit, Vs1 = 11 V, Vs2 = 22 V, R1 = 4 Ohm, R2 = 9 Ohm, R3 = 5.5 Ohm, R4 = 5 Ohm, R5 = 2.5 Ohm, R6 = 6 Ohm. B. Using mesh analysis, answer the following questions (Q2.2) Find the current through the resistor R1 in the direction from left to right. (Unit: A) Submit Answer Tries 0/3 (Q2.3) Find the current through the resistor R2 in the direction from...
Answer all three parts of the question Q2. For the op-amp circuit as shown below, given that Rs 6.5 kQ, R 23 k, R2-74 k2, R3 10.5 ka, R - 2 Vcc R2 RL R3 (Q2a) Determine the voltage gain G-vo/vs 3.1365 Submit Answer Incorrect. Tries 1/3 Previous Tries (Q2b) If vs= 1.5 v, find Thevenin equivalent circuit looking at vo towards the circuit by determining vm and Rh VTh (V)i RTh (k2) Submit Answer Tries 0/3 (Q2c) Determine Ry...
QUESTION 1 17.0 For the circuit shown below, the source voltages are VS1 = 32 V and VS2-20 V. Determine the voltage Vx (in volts). (Enter your answer as a number without the units.) 10 -6A S1 S2 10A 8A
The circuit shown in the figure below contains three resistors (R4, Ry, and R) and three batteries (V, Vs, and VJ. The resistor values are: Ry=2 Ohms, Ry=R3=6 Ohms, and the battery voltages are VA-25V, V, 15 V, and Vc=20 V. When the circuit is connected, what will be the power dissipated by R ? VC R R2 R3 O 10W © 20W 05.0W 06.0W 7.5 W
3. In the circuit shown below, the current flowing through Rs is to be measured by an ampermeter (a) What is the ampermeter reading if the internal resistance (R) of the ampermeter is zero. (b) Assume the ampermeter internal resistance (Rm) is 100 W, what is the measurement error caused by the resistance of the measuring instrument? Circuit Parameters Vsı = 12 V Ry = 400 Vs2 = 2 V R2 =6002 Rş = 1k R4 = 5000 Rs =...
The circuit shown in the figure below contains three resistors (Ry, Ry, and R) and three batteries (V, V, and V). The resistor values are: R2-2 Ohms, R, Ry-8 Ohms, and the battery voltages are VA 25V, V. 15 V, and Vc 20V. When the circuit is connected, what will be the power dissipated by Ry? Vc R R2 R3 O 0.75 W O 1.25 W O 2.67 w 42 w O 5.5 W