A sample of fully saturated clay weighs 1.4 kg. When dry, the same sample weighs 1.1...

Question

Question

Answer 1

Answer #1

Ginen Pata;- fully saturated weight (Wsat) = 1.4 kg Dory weight = weight of solids - Wa Wd = 1.1kg Density of solids (Is) = 2

Plzz give Positive Rating.. Thanks

Answer 2

Similar Homework Help Questions

2. A 63.7% saturated sample of soil has a dry density of 1680 kg/m 3 and...

2. A 63.7% saturated sample of soil has a dry density of 1680 kg/m 3 and a porosity of 37%. Find the void ratio and the specific gravity of the solids.
Remaining Time A saturated, normally consolidated clay has a water content of 30 percent, a liquid...

Remaining Time A saturated, normally consolidated clay has a water content of 30 percent, a liquid limit of 40 percent, and a plastic limit of 20 percent. The specific gravity of solids is 2.70. A saturated, normally consolidated clay has a water content of 30%, a liquid limit of 40, and a plastic limit of 20. The specific gravity of solids is 2.70. What is most nearly the compression index for this soil? O (A) 0.0030 (B) 0.27 O (C)...
1. A fully saturated clay sample has a volume of 180 cm and mass of 320...

1. A fully saturated clay sample has a volume of 180 cm and mass of 320 gm. the specific gravity of solids, G, is 2.6. Find the following parameters. (Use density of water, p, 1gm/em'and g-9.81 m/s) a Void ratio, 320 1.25 T-Gi8 1g 26xt ev el,0s b Porosity,-. ala0.us C Water content, LO.u39 us,1s Bulk Unit Weight, (ANm d 1x1 2.x0as.

A soil sample in its natural state has, when fully saturated, a water content of 32.5%....

A soil sample in its natural state has, when fully saturated, a water content of 32.5%. Determine the void ratio, dry and total unit weights. Calculate the total weight of water required to saturate a soil mass of volume 10 m. Assume G = 2.69.
2. A 30 cm sample of dry soil from an aquifer weighs 80 g. When the...

2. A 30 cm sample of dry soil from an aquifer weighs 80 g. When the soil is poured into a graduated cylinder, it displaces 25 mL of water. a. What is the porosity of the soil? b. What is the average density of the soil particles?
Q.1 (a) Soil sample has been collected in a compacted embankment at a dry density (Pty)...

Q.1 (a) Soil sample has been collected in a compacted embankment at a dry density (Pty) of 1950 kg/m, air void ratio (A.) of 15% and mass of solid (M.) of 3 kg. The value of G, is 2.7. Determine the following: O mass of water (MX) and total mass (M), (4 marks) (i) volume of air (V.), water (V.x) and solid (V.); (6 marks) (iii) void ratio (e), porosity (n), moisture content (w), and degree of saturation (S) and;...

Please show steps and explain briefly answers 9. A wet sample weighs 100 g was dried...

Please show steps and explain briefly answers 9. A wet sample weighs 100 g was dried up in the oven. The dry weight-80 g, then its moisture content is a) b) c) d) 80% 20% 25% none of the above (10 points) 10. The rock quality designation (RQD) is calculated by a)Dividing the length of all retrieved rock pieces by length of rock core b) Diiding the total length of all rock pieces 4" and longer by the length of...
the only question to answer are 2-5 2-7 2-10 2-17 2-19 thank you CHAPTER Two 2-3....

the only question to answer are 2-5 2-7 2-10 2-17 2-19 thank you CHAPTER Two 2-3. An undisturbed chunk of soil has a wet weight of 62 lb and a volume of o.s6 ft. When dried out in an oven, the soil weighs S0 Ib. If the specific gravity o solids is found to be 2.64, determine the water con- tent, wet unit weight of soil, dry unit soil. 2-13. The wet unit weight of a soil sample is 18.55...
Q.1 An excavated pit was backfilled by a soil with total volume of 0.5 m? The...

Q.1 An excavated pit was backfilled by a soil with total volume of 0.5 m? The total soil mass is 1000 kg. The moisture content (w) of the soil is 15% and its specific gravity (Gs) is 2.60. (a) Determine the following soil properties of the soil sample: (i) Density of soil solid, ps (2 marks) (ii) Volume of water, VX (2 marks) (iii) Volume of soil solids. Vs (2 marks) (iv) Volume of air, Va (1 mark) (v) Void...

e3 shows the soil profile (sand-clay-sand) at the site of a warehouse that causes a surface...

e3 shows the soil profile (sand-clay-sand) at the site of a warehouse that causes a surface ding of 100 kPa. (pw= 1000 kg/m; g 9.81 m/s2) on 4 (25 marks) A clay sample was cored at 7 m depth (middle of the clay layer). Based on laboratory test data, it was found that the clay was over-consolidated with OCR = 2.5 (before applying surface loading), compression index Ce 0.44 and recompression index C. = 0.1. The consolidation coefficient of clay...