Answer is option 5 that Router 2 doesn't advertise any network because if router 2 doesn't advertise then we can't make it as defualt router and without router there is no any other path to reach router 3 from router 1 due router 1 cant't ping router 3
Refer to the exhibit. Router-1 can not ping Router-3. Which statement identifies cause of the problem?...
Refer to the exhibit. Which of the following IP addresses will be chosen as EIGRP Router-ID? RT ship interface brier Interface IP-Address GigabitEthernet0/0 10.10.0.2 GigabitEthernet0/1 192.168.15.2 Loopbacko 1.1.1.1 Loopbacki 172.17.10.1 vlani unassigned OK? Method Status Protocol YES manual up up YES manual up up YES manual up up YES manual up up YES unset administratively down down router ospf 1 log-adjacency-changes network 192.168.1.0 0.0.0.255 area 0 network 172.16.0.0 0.0.255.255 area 0 O 10.10.0.2 O 172.17.10.1 O 1.1.1.1 O 192.168.15.2
Refer to the exhibit. Router-1 can not establish adjacency with Router-2. Which one is the correct response to solve this problem? OSPF Area 0 G0/0 10.10.10.0/24 G0/0 cost 1500 MTU 1522 cost 1522 MTU 1500 Router 1 Router 2 Assign default cost value on both router interfaces O Reduce the MTU on Router-1 to 1500 run command 'network 10.10.10.0 0.0.0.255 area 0 Increase the OSPF cost value on Router-1 to 1522, and increase the MTU value on Router-2 to 1522...
Which commands can be used to configure a router to run EIGRP and advertise network 192.168.16.0/24? (choose two) Router(config)#router eigrp Router(config-router)#network 192.168.16.0 0.0.0.255 area 0 Router(config-router)#network 192.168.0.0 0.0.240.255 area 0 Router(config-router)#network 192.168.16.0 255.255.255.0 Router(config)#router eigrp area 0 Router(config)#router eigrp 1 Which two are features of EIGRP routing protocol? (Choose two) EIGRP is a classful routing protocol Can summarize routes at any points in the network Converge quickly Before finding out neighbors, EIGRP routers exchange routing information Identify the best route...
Refer to the exhibit. The output of 'show interface g0/0' command on Router-1 can be used to troubleshoot EIGRP adjacency problem. 30/0 80/1 Router 1 Router 2 OK? Method Status Rlish ip interface brief Interface IP-Address Protocol GigabitEthernet0/0 10.10.0.2 GigabitEthernet0/1 unassigned down vlani unassigned down YES manual up up YES unset administratively down YES unset administratively down O True O False Why does OSPF uses Designated Router(DR)? (choose two? Reduce the number of adjacencies over a multiaccess network To summaries...