A 380-N, uniform, 1.25-m bar is suspended horizontally by two vertical cables at each end. Cable...
A 380-N, uniform, 1.25-m bar is suspended horizontally by two vertical cables at each end. Cable A can support a maximum tension of 512.0 N without breaking, and cable B can support up to 443.0 N. You want to place a small weight on this bar.
What is the heaviest weight you can put on without breaking either cable?
Where should you put this weight?
Homework Answers
Add Answer to:
A 380-N, uniform, 1.25-m bar is suspended horizontally by two
vertical cables at each end. Cable...
A 352-N, uniform, 1.68-m bar is suspended horizontally by two vertical cables at each end. Cable...
A 352-N, uniform, 1.68-m bar is suspended horizontally by two vertical cables at each end. Cable A can support a maximum tension of 516.0 N without breaking, and cable B can support up to 434.0 N . You want to place a small weight on this bar Part A What is the heaviest weight you can put on without breaking either cable? Part B Where should you put this weight?
A 358-N, uniform, 1.44-m bar is suspended horizontally by two vertical cables at each end. Cable...
A 358-N, uniform, 1.44-m bar is suspended horizontally by two vertical cables at each end. Cable A can support a maximum tension of 459.0 N without breaking, and cable B can support up to 439.0 N . You want to place a small weight on this bar. A) What is the heaviest weight you can put on without breaking either cable? w=_____N B) Where should you put this weight? d=______m from the cable A
A 397-N, uniform, 1.32-m bar is suspended horizontally by two vertical cables at each end. Cable...
A 397-N, uniform, 1.32-m bar is suspended horizontally by two vertical cables at each end. Cable A can support a maximum tension of 510.0 N without breaking, and cable B can support up to 413.0 N . You want to place a small weight on this bar. Part APart complete What is the heaviest weight you can put on without breaking either cable? Part B Where should you put this weight, what is d?
A 338-N, uniform, 1.62-m bar is suspended horizontally by two vertical cables at each end. Cable...
A 338-N, uniform, 1.62-m bar is suspended horizontally by two vertical cables at each end. Cable A can support a maximum tension of 549.0 N without breaking, and cable B can support up to 417.0 N . You want to place a small weight on this bar. Here is what I have so far... Part A What is the heaviest weight you can put on without breaking either cable? w = 628 N <--- Correct Correct Part B Where should...
A 12.0 m uniform beam is hinged to a vertical wall and held horizontally by a...
A 12.0 m uniform beam is hinged to a vertical wall and held horizontally by a 5.00 m cable attached to the wall 4.00 m above the hinge, as shown in the figure below (Figure 1).The metal of this cable has a test strength of 0.900 kN which means that it will break if the tension in it exceeds that amount. You may want to review For related problem solving tips and strategies, you may want to view a Video...
2)A 3 meter rod with a weight of 1000 N is suspended by two cables and...
2)A 3 meter rod with a weight of 1000 N is suspended by two cables and has a large box(3500 N in weight ) tied to the right hand side hanging vertically. The center of mass of the rod is.5 min from the leftmost edge. One cable is exactly on the leftmost end of rod with a tension of 4000 N at an angle of 30 degrees to rod . The second cable is 1 m to the right of...
In the figure, a uniform beam of weight 550 N and length 2.3 m is suspended...
In the figure, a uniform beam of weight 550 N and length 2.3 m is suspended horizontally. On the left it is hinged to a wall; on the right it is supported by a cable bolted to the wall at distance D above the beam. The least tension that will snap the cable is 1100 N What value of D corresponds to that tension? Number Units im The number of significant digits is set to 2, the tolerance is +/-1%
A weight W= 500 N is suspended from two identical cables AB and BC, each with a weight of q= 10 N...
A weight W= 500 N is suspended from two identical cables AB and
BC, each with a weight of q= 10 N/m. If the maximum horizontal
force allowed on the support cable is of 800 N, find: a) The
shortest possible length of cable ABC. b) The height h on the
previous situation. a= 20 m.
6) A uniform 1200 N weight beam that is 3,50 m long is suspended horizontally by...
6) A uniform 1200 N weight beam that is 3,50 m long is suspended horizontally by two vertical wires at its ends, A small but dense 550 N weight is placed on the beam 2.00 m from one end as shown in the figure. The tension in wire A in Newtons is 2.00 m A) 914 B) 8190 C) 875 D) 836 E) 8960 7) In problem 14) the tension in wire B in Newtons is A) 875 8) 8960...
(1 point) A non-uniform bar of weight W = 47.5 N is suspended at rest in...
(1 point) A non-uniform bar of weight W = 47.5 N is suspended at rest in a horizontal position by two massless cords. The angle phi between cord 2 and the vertical is equal to 45.0°. The bar has a length L = 8.0 m and the distance of its center of gravity from the left-hand end of the bar is 4.3 m. What is the tension in cord 2? What is the angle theta between cord 1 and the...
A 12.0 m uniform beam is hinged to a vertical wall and held horizontally by a 5.00 m cable attached to the wall 4.00 m above the hinge, as shown in the figure below (Figure 1).The metal of this cable has a test strength of 0.900 kN which means that it will break if the tension in it exceeds that amount. You may want to review For related problem solving tips and strategies, you may want to view a Video...
2)A 3 meter rod with a weight of 1000 N is suspended by two cables and has a large box(3500 N in weight ) tied to the right hand side hanging vertically. The center of mass of the rod is.5 min from the leftmost edge. One cable is exactly on the leftmost end of rod with a tension of 4000 N at an angle of 30 degrees to rod . The second cable is 1 m to the right of...
In the figure, a uniform beam of weight 550 N and length 2.3 m is suspended horizontally. On the left it is hinged to a wall; on the right it is supported by a cable bolted to the wall at distance D above the beam. The least tension that will snap the cable is 1100 N What value of D corresponds to that tension? Number Units im The number of significant digits is set to 2, the tolerance is +/-1%
A weight W= 500 N is suspended from two identical cables AB and
BC, each with a weight of q= 10 N/m. If the maximum horizontal
force allowed on the support cable is of 800 N, find: a) The
shortest possible length of cable ABC. b) The height h on the
previous situation. a= 20 m.
6) A uniform 1200 N weight beam that is 3,50 m long is suspended horizontally by two vertical wires at its ends, A small but dense 550 N weight is placed on the beam 2.00 m from one end as shown in the figure. The tension in wire A in Newtons is 2.00 m A) 914 B) 8190 C) 875 D) 836 E) 8960 7) In problem 14) the tension in wire B in Newtons is A) 875 8) 8960...
(1 point) A non-uniform bar of weight W = 47.5 N is suspended at rest in a horizontal position by two massless cords. The angle phi between cord 2 and the vertical is equal to 45.0°. The bar has a length L = 8.0 m and the distance of its center of gravity from the left-hand end of the bar is 4.3 m. What is the tension in cord 2? What is the angle theta between cord 1 and the...
Most questions answered within 3 hours.
-
Which of the following items may not create an NOL?
a.
sole proprietorship loss
b.
personal...
asked 32 seconds ago -
when 2053 j of heat is added to 46.3 g of hexane C6H14 the
temperature increases...
asked 1 minute ago -
a)An ideal heat pump is being considered for use in heating an
environment with a temperature...
asked 2 minutes ago -
.
Convert the following pairs of voltage and current waveforms to
phasor form. Each pair of...
asked 3 minutes ago -
I need new and unique answers, please. (Use your own words,
don't copy and paste), Please...
asked 4 minutes ago -
A 6.5 cm diameter ball has a terminal speed of 22 m/s. What is
the ball's...
asked 17 minutes ago -
Name two areas of the human body with the highest concentration
of lymph nodes and speculate...
asked 21 minutes ago -
Angel Corporation has $10,000,000 of
8.0% 25 year bonds dated May 1, 2018 with interest payable...
asked 55 minutes ago -
7.
________ involves individuals trading goods they already have or
providing services in exchange for something...
asked 1 hour ago -
Share your research problem. What databases did you search as
you gathered evidence to support your...
asked 1 hour ago -
what process occurs to form microspores and megaspores in flowering
plants?
asked 1 hour ago -
C++
I need to use the function getData to put in all my data using
arrays....
asked 1 hour ago