< Hw.e CH-30 Induction and Faraday's law Problem 30.25 Part A What is the potential difference...

Question

Question

Answer 1

Answer #1

a)

e = L di/dt

e = 0.14* 0.08 / (16* 10^-6)

e = 700 V

=====

b)

potential increases

=====

comment in case any doubt, will reply for sure.. goodluck

Answer 2

Similar Homework Help Questions

What is the potential difference across a 15 mH inductor if the current through the inductor...

What is the potential difference across a 15 mH inductor if the current through the inductor drops from 160 mA to 50 mA in 15 micro seconds?
faraday's law of electromagnetic induction says that if there is relative motion between any conductor and...

faraday's law of electromagnetic induction says that if there is relative motion between any conductor and magnetic field an induced emf is induced in the conductor and if the conductor is cloesd loop then induced current will also start to flow. my question is that where are the points on the loop across which the potential difference generated so that current can flow, because the current flows only due to potential difference
What is Faraday's Law? o It defines the induced voltage across a coil when the magnetic...

What is Faraday's Law? o It defines the induced voltage across a coil when the magnetic field going through it changes. o It gives the direction of the induced current going through a coil when the magnetic field going through it changes. O The potential difference across a resistor is proportional to both the resistance and the current going through it O The sum of all the current going into a junction has to equal the sum of all the...

The current in a 200 mH inductor is i = 75 mA, t < 0; -50+...

The current in a 200 mH inductor is i = 75 mA, t < 0; -50+ i= (B1 cos 200t + B2 sin 200t) e A, t>0, where t is in seconds. The voltage across the inductor (passive sign convention) is 4.25 V at t = 0. Part A Calculate the power at the terminals of the inductor at t = 28 ms Express your answer to three significant figures and include the appropriate units. μΑ p = Value Units...
The current in a 200 mH inductor is i=75 mA, t< 0; i= (B cos 200t...

The current in a 200 mH inductor is i=75 mA, t< 0; i= (B cos 200t + B, sin 2000) e -50t A, t>0, where t is in seconds. The voltage across the inductor (passive sign convention) is 4.25 V at t = 0. Part A Calculate the power at the terminals of the inductor at t = 24 ms Express your answer to three significant figures and include the appropriate units. μΑ ? p= Value Units Submit Request Answer...
4. A practical galvanic cell is colloquially known as a "battery". Is Faraday's law in any...

4. A practical galvanic cell is colloquially known as a "battery". Is Faraday's law in any way applicable to using a battery (hence a galvanic cell)? If so, how? (Hint: Did you see the waterfall or water + gravity analogy in the tutorial? Difference in height is not the only important waterfall parameter). 5. Ideally, determination of cell emf is a steady-state experiment with no net change in concentrations of ions and no current flowing. However, using a battery (galvanic...

Ch 30 HW (Part 1) Problem 30.72 10 of 15 Constants | Periodic Table At t...

Ch 30 HW (Part 1) Problem 30.72 10 of 15 Constants | Periodic Table At t = 0, the current through a 44.0 mH inductor is 42.0 mA and is increasing at the rate of 88.5 mA/s . Part A What is the initial energy stored in the inductor, and how long does it take for the energy to increase by a factor of 7.0 from the initial value? Express your answer using three significant figures. U U = nothing...
help with these three <Chapter 23 Problem 23.55 < 8 of 1 RE The circuit shown...

help with these three <Chapter 23 Problem 23.55 < 8 of 1 RE The circuit shown in the figure (Figure 1) consists of a 5.1- V battery, a 32-mH inductor, and four 58-22 resistors. Part A Find the characteristic time for this circuit. Express your answer using two significant figures. IV AX O ? Figure < 1 of 1 > Submit Request Answer pa0000 Part B What is the current supplied by this battery two characteristic time intervals after closing...
PLEASE BOX THE ANSWERS FOR A THUMBS UP Problem 6.9 The current in a 15 mH...

PLEASE BOX THE ANSWERS FOR A THUMBS UP Problem 6.9 The current in a 15 mH inductor is known to be -10A fort < 0 and (-10 cos 400t – 5 sin 400t) e -2004 A fort > 0. Assume the passive sign convention. Part A At what instant of time is the voltage across the inductor maximum? Express your answer with the appropriate units. μΑ ? t = Value Units Submit Request Answer Part B What is the maximum...

cu nu <Chapter 19 Problem 19.16 2 of 16 Constants - Part A In a laboratory...

cu nu <Chapter 19 Problem 19.16 2 of 16 Constants - Part A In a laboratory experiment, you vary the current through an object and measure the resulting potential aference across in each case. (Figure 1) shows a graph of this potential as a function of the current Does Ohm's low apply to this object? Why do you say 507 Match the words in the left column to the appropriate blanks in the sentences on the night Figure 1 of...