the factor of safety is more in distortion energy method than the maximum shear stress method.
Please complete all of #6 :) your result to that from the previous step). 6. Repeat...
4. Here is a similar problem with pulleys and shafts, complicated slightly due to the fact that there are forces in two planes, not just one, as previously. Dimensions in the figure are in mm. Some additional dimensions are: dahaft 18 mm 200 mm300 mm 300 400 Ts Te 150 d Assume bearings 0 and C are frictionless. Assume tensile forces are T = 200 N and Ti 40 N. Further assume steady-state operation. (a) On pulley A, suppose the...
please answer all thank you Homework - State Loading Advanced (Part 2) A solid round 20 mm diameter hur is based as shown below, where the lead iP XOAN, the downward tr adise.SSAN, the lig h the is M-20 Nm, and the true lead is T-30 Nm. This results in certain stresses in the bar the base al Points located at the top of the har d ew from (located ISO w from 4-y il Decated 270cw from located in...
I need help to write a nice introduction for experiment 6 please ( no hands write ) typing Thank you HEAT TREATMENT OF STEELS EXPERIMENT 6 EXPERIMENT 6 HEAT TREATMENT OF STEELS THEORY The Effect of Cooling Rate One of the most convenient methods for controlling the properties of a given steel, i.e., a steel whose composition is already fixed, consists of austenizing the steel and ten cooling to room temperature at some predetermined rate. A variation of cooling rates...