#3) For an AM-TC signal, the positive envelope of the modulated signal is within the range...
below is used to modulate a carrier to generate the AM signal yt) (Am()) cos(1000t) The periodic signal m() shown a) The power efficiency of the system is measured to be 1 () The type of AM modulation, i.e. SSB, DSBSC, (i) The constant A. (ili) The modulation index 1/13. Determine DSB with carrier enit -3 b) An angle modulated signal is given by d(t-2 cos (2n1061+ sin 2 1000). Find i) The carrier frequency. ii) The baseband signal bandwidth....
Consider an AM system. The message signal is given by cos(1000t) volts. The modulated signal is (0.5+acos(1000m))cos(2π.) volts, where α is a positive coefficient, and fe is the carrier frequency. (a) Determine the value of α when the modulation index is 100%. (b) Determine the value of α when the modulation index is 50%. (c) Determine the value of α when the modulation index is 200%. (6 marks) Continue from (1) and suppose α-05. Sketch the spectrum of the transmitted...
Question 4: (20 points) An FM signal is modulated with message m(t)Am cos(2Tmt). The measured amplitude spectrum, SPM(f), is shown below: Amplitude spectrum of the frequency modulated signal 2 -2 5000 4000 3000 2000 -1000 1000 2000 3000 4000 5000 frequency f [Hz] a) What is the carrier frequency fe? b) What is the message frequency fm c) What is the FM modulation index Bf? Is it a narrowband or a wideband signal? d) Using Carson's rule, estimate the transmission...
Assume that an AM transmitter is modulated with a video testing signal given by em(t) = =20 + 60 sin (2πf1t), where f1 = 3.57 MHz. Let the carrier signal c(t) = Ac cos(2πfct), where Ac = 100 and fc = 100 MHz. The AM signal is fed into a 50-Ω load. (a) Derive an expression for the AM DSB-FC signal in time domain. (b) Construct the AM waveform, giving numerical values of the maximum amplitude, Amax and the minimum...
When a baseband signal m(t) = cos(1000t)cos(3000t) is AM modulated using a carrier cos(10,000t), a) Find the frequency components in the baseband signals and in the AM signal. [2] b) Sketch the spectrum, carefully label the graph. c) Find the power efficiency, n. [1] [1]
Use MATLAB to plot the AM DSBSC modulated signals with modulation index m=0.25,0.5,0.8,1.0,1.2,1.5,2.0 with carrier signal c(t)=20cos(2pi20000t) and massage signal m(t)=Vm cos(2pi3000t) along with the envelope.
1 2 4. The amplitude modulation signal is given by the following expression and is applied to 75 load. Vam(t) = 10 sin (21fct) - 2.5 cos (1500krt) + 2.5 cos (1450krt) V Determine: a) Modulation index b) The frequency of the carrier and the information signal c) The bandwidth d) The total power e) The transmission power efficiency be ar e 5. One of the inputs to a frequency modulator is a 250 kHz carrier signal with amplitude of...
Please write clearly Expert Q&A Done 6. (A) What is an amplitude modulation (AM)? [) A baseband message signal mt) is shown below. b shows the frequency spectrum of mýtj. A carrier signal cost was used in DSB-SC AM moduition of m/t). Describe how the modulated signal can be created (is) Draw the frequency spectrum of modulated signal. (iv) Describe how the message signal demodulated and recovered at the receiving side. (4 5 20 points)
BJTU Fall 2018 0 Problems 6-1 The amplitude of the modulated signal is 2.4V, the maximum frequency offset of the FM wave is 4.8kHz, and the modulation index of the PM wave is mp=5. (1)Try to find the FM index and PM index for the modulation frequency of 500Hz and 1kHz. (2) Assuming that the modulation frequency is 2 kHz, but the amplitude of the modulation signal is increased to 7.2 V, calculate the modulation index of the FM wave...
8.4 Mixers 8.21* An AM signal is transmitted on an 800-kHz carrier. The baseband frequency range extends from 100 Hz to 5 kHz. This signal is to be detected by a superheterodyne receiver with a 55-kHz intermediate frequency. (a) What is the frequency of the local oscillator? (b) What must be the Q of the IF stages if the 1-dB points are to correspond to the maximum and minimum frequencies of the IF signal?