Your company is designing a cap for a pressure vessel and needs to determine if it's viable. Given the figure above and the data below:
Determine the number of bolts to have a "Joint Factor of Safety" (Joint separation) of 4 or slightly over
Round the value up to nearest integer if necessary
Total force (P) from the pressure vessel
Pressure(ksi) = 60
Area (in^2) = 4
P_Total = 15000 lbf*
*Assume that applied force is distributed among the bolts
Bolt: 3/8-24 x 1.7 in UNF -2B SAE Grade 5 Hex head boltE (young's, MPsi) = 30
Carbon Steel bolt
Permanent connection? No
Bolt Condition: Nonplated
Washer:
Narrow or Wide? narrow
Plate 1:
Material - Carbon Steel
E = 30 MPsi
poisson's = 0.292
thickness = 0.5 in
Plate 2:
Material - Molybdenum
E = 48 MPsi
Poissons = 0.307
thickness = 1.0 in
Assume alpha for frustum = 30 degrees
Your company is designing a cap for a pressure vessel and needs to determine if it's...
QUESTION 2 The end-cap of a pressure vessel as shown in Figure 2 is secured by 10 off M10 x SAE class 10.9 bolts (with rolled threads). A soft gasket is used such that the clamped member stiffness is one quarter of the bolt stiffness. The internal diameter of the pressure vessel is 140 mm and the pressure in the vessel varies from 0 to P MPa gauge. Assuming that the bolts are initially tightened to 80% of their yield...
[3. (3 marks) Two steel plates each of 1.0 inch thickness (E-30 MPsi) are joined by SAE grade 8 bolt and no washers. Assume the bolt specification to be 34-10 UNC and bolt length of 2.75 inch. The joint is subjected to a fluctuating load from 1000 lbf to 9000 lbf. The yield strength of the plate material is 60 kpsi. Neglect the stress concentration in the threads of the bolt. Determ ine the following: [a]. whether the bolt is...
Q3 (30) A cylindrical pressure vessel is constructed from a long, narrow steel plate by wrapping the plate around a mandrel and then welding along the edges of the plate to make a helical joint α 55° with the longitudinal axis. The vessel has inner radius r-1.8 m and wall thickness t 20 mm. The material is steel with modulus E: 200 GPa and Poisson's ratio0.30. The internal pressure p is 800 kPa Helical weld . The helical weld makes...
em 35? ? A cylindrical pressure vessel is constructed from a long, narrow steel plate by wrapping the plate around a mandrel and then welding along the edges of the plate to make a helical joint. The helical weld makes an angle ? 350 with the axial direction. The vessel has inner radius r = 1.8 m and wall thickness 20 mm. The material is steel with E 200 GPa and Poisson ratio 0.3. The internal pressure p = 800...