4. A load with a mass of 10000 kg is hung on the end of the...

Question

Question

4. A load with a mass of 10000 kg is hung on the end of the crane as shown in the figure below. The crane is pivoted at point

Answer 1

Answer #1

1 . broram of crane (Ra, R e prane R. Fu e borces acling T , Mg are you on the crane) M= 4000 kg weight of toookg mass is bal

Answer 2

Similar Homework Help Questions

A crane of mass m1 = 3 225 kg supports a load of mass m2 =...

A crane of mass m1 = 3 225 kg supports a load of mass m2 = 12 100 kg as shown in the figure below. The crane is pivoted with a frictionless pin at A and rests against a smooth support at B. (a) Find the reaction forces at point A. horizontal component: Magnitude/Direction vertical component: Magnitude/Direction (b) Find the reaction forces at point B. horizontal component: Magnitude/Direction vertical component: Magnitude/Direction
Gate AB in Figure A2 is a homogeneous mass of 180 kg, 1.2 m wide into...

Gate AB in Figure A2 is a homogeneous mass of 180 kg, 1.2 m wide into the paper, hinged at A, and resting on a smooth bottom at B. All fluids are at 200 C. a) If the moment about the centre of gravity of a submerged plate at an angle e is defined as FYCP = Then show that this moment is given by [5marks] [3 marks b) Draw a diagram with all forces acting on the gate AB...
5. A uniform 8.0 m long ladder of mass 10.0 kg leans against a wall. The...

5. A uniform 8.0 m long ladder of mass 10.0 kg leans against a wall. The wall is smooth and the floor is rough. The coefficient of static friction between the ladder and the floor is 0.35 (i) Draw a sketch and free body diagram. (ii) Find the reaction force from the wall. (iii) Find the normal force at the ground. (iv) Find the minimum angle at which the ladder does not slip.

Q.1) The crane arm is pinned at point A and has a mass of 200 kg...

Q.1) The crane arm is pinned at point A and has a mass of 200 kg whose weight is acting at a point 2 m to the right of point A. The mass of the block is 800 kg. If the crane is in equilibrium, find (a) the magnitude of the force exerted on the arm by the hydraulic cylinder BC, (b) the support reactions at point A. OOOO 2.4 m - 1.8 m - 1.2 m -7 m
A ladder of length 12.0 m with a mass of 40.0 kg leans against a smooth...

A ladder of length 12.0 m with a mass of 40.0 kg leans against a smooth wall. The ladder makes a 35.0o angle with the horizontal. Draw an adequate free body diagram of the ladder and determine the minimum coefficient of static friction between the ladder and the ground necessary to prevent the ladder from slipping.
A ladder of length 12.0 m with a mass of 40.0 kg leans against a smooth...

A ladder of length 12.0 m with a mass of 40.0 kg leans against a smooth wall. The ladder makes a 35.0 degree angle with the horizontal. Draw an adequate free body diagram of the ladder and determine the minimum coefficient of static friction between the ladder and the ground necessary to prevent the ladder from slipping.

III. A 3.0 m long and 2.0 m wide carton of mass 100 kg leans against a smooth wall as shown in the figure. The coef...

III. A 3.0 m long and 2.0 m wide carton of mass 100 kg leans against a smooth wall as shown in the figure. The coefficient of static friction between the floor and the lower end of the carton is 0.80. The normal force at the floor is:
III. A 3.0 m long and 2.0 m wide carton of mass 100 kg leans against...

III. A 3.0 m long and 2.0 m wide carton of mass 100 kg leans against a smooth wall as shown in the figure. The coefficient of static friction between the floor and the lower end of the carton is 0.80. The normal force at the floor is: a. 240 N b. 100 N c. 980 N d. 80 N e. None of the above
III. A 3.0 m long and 2.0 m wide carton of mass 100 kg leans against...

III. A 3.0 m long and 2.0 m wide carton of mass 100 kg leans against a smooth wall as shown in the figure. The coefficient of static friction between the floor and the lower end of the carton is 0.80. The normal force at the floor is: a. 240 N b. 100 N c. 980 N d. 80 N Totates through

Fish are hung on a spring scale to determine their mass (most fishermen feel no obligation...

Fish are hung on a spring scale to determine their mass (most fishermen feel no obligation to report the mass truthfully). (a) What is the force constant (in N/m) of the spring in such a scale if it stretches 7.60 cm for a 10.5 kg load? N/m (b) What is the mass (in kg) of a fish that stretches the spring 5.50 cm? kg (c) How far apart (in mm) are the half-kilogram marks on the scale? mm