ZuoTi.Pro
Question

Determine the theoretical spectral content of the OOK signal. Assume a carrier frequency of 100 KHz, a data rate of 5 Kbps, and a normalized data level of 1 V Express the spectrum amplitude in linear scale(V) and dBV (20log Vms). Note that data is not a periodic signal, and use the maximum possible data frequency in your calculations.

media%2F765%2F765f34ec-5f86-4f89-a1b7-21

do anyone know the equation I have to use to solve this problem? this have to do with the On-Off keying and ASK modulation.

engineering   Electrical-Engineering   
0 0
Add a comment Improve this question Transcribed image text
Next > < Previous
Sort answers by oldest

Homework Answers

Answer #1

dc Amplitude Skiit ktzjng om- off keg Ken the Simplet dig tak modulotem technie and thtue ia oy me Sequente Ask modulat col s371 -t 5-ון (I 2 71 τι VASK ()-! 2 TI 2 Tt 6T1 Va) c )VAsx (w ASk -10 K ㅡ.lor K-100 KHI

0 0
Add a comment
Know the answer?
Add Answer to:
do anyone know the equation I have to use to solve this problem? this have to...
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Log In

Sign Up

Not the answer you're looking for? Ask your own homework help question. Our experts will answer your question WITHIN MINUTES for Free.
Similar Homework Help Questions

  • can someone help me do this and maybe also the picture of the scope explain how you get it. thankyou! Frequency-sh...

    can someone help me do this and maybe also the picture of the scope explain how you get it. thankyou! Frequency-shift keying (FSK) and Phase-shift keying (PSK) Two other modulation schemes are the phase-shift keying (PSK) and the frequency-shift keying (FSK). These are illustrated in Figure 8 b and c respectively. In phase-shift keying the carrier signal changes phase by a radians when the digital signal changes values. In frequency-shift keying a 0 is transmitted at a different carrier frequency...

  • Communication System Solve with ALL steps Please QUESTION 3 Briefly explain the following Analog Pulse Modulation...

    Communication System Solve with ALL steps Please QUESTION 3 Briefly explain the following Analog Pulse Modulation (APM): (i) Pulse Amplitude Modulation (PAM) Pulse Width Modulation (PWM) (iii) Pulse Position Modulation (PPM) (2 marks) (2 marks) (2 marks) b) There are several digital modulations techniques used to modulate digital signal. For a binary data 10111011, sketch the output waveform if the following modulator is used: Amplitude Shift Keying (ASK) (2 marks) Frequency Shift Keying(FSK) (2 marks) (iii) Phase Shift Keying (PSK)...

  • Please do Part 4 and Show all work! 1. 145 points) <FM/FSK Modulation/Demodulations A periodic wave m(t) in Figure 1 below The resulting FM signal is demodulated as shown in the following figure b...

    Please do Part 4 and Show all work! 1. 145 points) <FM/FSK Modulation/Demodulations A periodic wave m(t) in Figure 1 below The resulting FM signal is demodulated as shown in the following figure by using frequency discriminator. Assume no attenuation of the signal due to propagation loss (in other words assume amplifiers properly restored the amplitude of the transmitted signal at the receiver) [10 points] Find the Fourier Series (trigonometric Fourier Series) of the message signal m (t) where To...

  • Communication Engineering

    The technique sometimes used to      make an information signal compatible with the medium over which it is      being transmitted is called? ModulationWhat is the name given to undesirable      interference that is added to a signal being transmitted? NoiseName the technique used to      extract multiple intelligence signals that have been transmitted      simultaneously over a single communication channel. MultiplexingIn the electromagnetic wave      spectrum, the frequency of radio waves ranges from...

  • Hi everyone, I have a question about active filter, including a simulation, Please provide the sc...

    Hi everyone, I have a question about active filter, including a simulation, Please provide the screen capture. Thanks. 5. Active Filter - III Consider the RC op-amp circuit shown in Fig. 5.4. Vin(t) is a sinusoidal signal with Vpp = 1 V, Rı = 10 ㏀ , R, = 20 ㏀ , and C,-C,-0.01 μF. Use Vcc-15V, The capacitors have zero initial energy stored. Ri 741 C1 C2 Volt) Fig. 5.5: Active filter - III (a) Find the transfer function...

  • Program in any language. I need help I have no idea how to do this! (1)...

    Program in any language. I need help I have no idea how to do this! (1) Write a program to combine 2 (two) waves with different frequencies (fm and fc) using AM (Amplitude Modulation) technique: y(t) = [1 + m cos(2 π fn t) ] A sin(2 π ) where fm is the modulated frequency, fc is the carrier frequency, A- Amplitude, m- index of modulation, t time and 3.14159265359 (A) Plot y(t) in time domain t = 0 to...

  • DC-AC inverters have many commercial and residential applications, including uninterruptible powe...

    DC-AC inverters have many commercial and residential applications, including uninterruptible power supply (UPS) units, adjustable speed drives (ASD) for AC motors, and electronic frequency changer circuits. They are also used in solar electrical systems where batteries are charged from solar panels and used as the input DC voltage source. The inverter circuit converts the DC into AC voltage of desired frequency. Most of us are also familiar with HVDC transmission systems, where high voltages are first converted from AC to...

ADVERTISEMENT
Free Homework Help App
Download From Google Play
Scan Your Homework
to Get Instant Free Answers
Need Online Homework Help?
Ask a Question
Get Answers For Free
Most questions answered within 3 hours.
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT