Discuss the differences (relative features, pros and cons) between original amplitude modulation (AM) and double-sideband suppressed...
An information signal is of the form s(t) = sin(2*pi*t)/t. The signal amplitude modulates a carrier of frequency 10Hz. Find and sketch the Waveform and Fourier transform of the transmitted signal before and after AM modulation. For AM modulation you can consider the simple case of DSB format (or double-sideband suppressed carrier modulation).
Double Side Band with Suppressed Carrier (DSBSC) signal under Digital Sound Processing: Amplitude modulation (AM) technology is used where the modulating signal is given as ?(?)=1+5.5cos(9600??) while the carrier is given as ?(?)=2cos(96000??)+4cos (144000??). How do you obtain the receiver carrier and the bandwidth of the recovering filter so as to recover the modulating signal?
Please answer FAST ASAP I will rate you thumbs up ?? (1) What are the reasons behind the need of modulation for radio transmission, i.e., why not directly transmit the original signal? Q2) A carrier signal with frequency f. Hz is double-sideband suppressed carrier (DSB-SC) amplitude modulated by a triangular shaped message signal, m(t), plotted below (Fig. Q2). The DSB-SC amplitude modulated signal is then passed from a band-pass filter with center frequency fc-Im and bandwidth 2fm where fm =...
Amplitude modulation: double side band supressed carrier (DSB-SC) why is DSB-SC used for radio signals? which frequency components would carry useful information and which ones would cause unnecessary interference?
2. (14 points) This problem shows an example of using the Fourier transform to analyze communication systems. The system in Figure 4, where (t)-f(t)+sin(wt) and has been proposed for amplitude modulation. f(t) + sin(o) Figure 4: System proposed for amplitude modulation. (a) (7 points) The spectrum of the input f(t) is shown in Figure 1, where 2mB o/100. Sketch and label the spectrum Y(w) of the signal y(t). Hint: You will need to use the frequency convolution property of the...
Please write clearly Expert Q&A Done 6. (A) What is an amplitude modulation (AM)? [) A baseband message signal mt) is shown below. b shows the frequency spectrum of mýtj. A carrier signal cost was used in DSB-SC AM moduition of m/t). Describe how the modulated signal can be created (is) Draw the frequency spectrum of modulated signal. (iv) Describe how the message signal demodulated and recovered at the receiving side. (4 5 20 points)
What are the main differences between social and private insurance? Discuss the pros and cons of each. 150 words no duplicate answers
An AM receiver is tuned to broadcast station at 600 kHz. Calculate the image rejection in dB, assuming that the input filter consist of one tuned circuit with a Q of 40? An SSB system transmit a peak envelope power of 100 W into a 75 ohms load. The carrier signal is modulated by two tones, with frequencies 2 kHz and 3 kHz with equal magnitude and only the lower sideband is transmitted with a suppressed carrier. Determine the average...
An AM receiver is tuned to broadcast station at 600 kHz. Calculate the image rejection in dB, assuming that the input filter consist of one tuned circuit with a Q of 40? An SSB system transmit a peak envelope power of 100 W into a 75 ohms load. The carrier signal is modulated by two tones, with frequencies 2 kHz and 3 kHz with equal magnitude and only the lower sideband is transmitted with a suppressed carrier. Determine the average...
Discuss the differences between the following pros and cons of each to measure profit: a. Gross profit b. Operating income (EBIT) c. Net Income. It can be very brief