Homework Answers
In this circuit, there can be seen three parallel branches, resistive, inductive and capacitive.
If current in resistive branch is at 0 degree( reference) then the current in inductive branch lags this current and the current in capacitive branch leads this current. These values of lag and lead angle depends on Reactances ( i.e. frequency).
Add Answer to:
w To the right is a complex circuit. The maximum voltage of the source is 10...
3. Consider the AC circuit shown in the figure below, consisting of an alternating voltage source—of...
3. Consider the AC circuit shown in the figure below, consisting
of an alternating voltage source—of voltage V (t) = V0 cos (ωt)—a
capacitor (of capacitance C), an inductor (of inductance L), and
two resistors (of resistances R1 and R2). Also, note the
highlighted points a and b in the circuit. (a) While explaining
your reasoning, determine the necessary condition that must be
satisfied between the circuit elements such that the potential
difference between points a and b is zero...
A series LRC circuit is driven by an ac source with a voltage amplitude of 36.0...
A series LRC circuit is driven by an ac source with a voltage amplitude of 36.0 V and a frequency of 60.0 Hz. The resistance is 160 Ohm, the inductance is 0.230 H, and the capacitance is 70.0 mu F. a) Determine the impedance of the circuit. b) Determine the current amplitude. c) Determine the voltage amplitude across (i) the resistor, (ii) the inductor and (iii) the capacitor. d) Sketch the phasor diagram (at t = 0) for the circuit,...
We have a series RLC circuit with an AC voltage source: The resistance is 100Ohm, the inductance ...
We have a series RLC circuit with an AC voltage source: The resistance is 100Ohm, the inductance is 10mH, the capacitance is 10mF. Select all the right answers. At 60Hz What is true? Question 10 options: The current through the inductor is larger than through the resistor The voltage across the inductor is larger than the voltage across the capacitor The voltage is lagging behind the current at the source The voltage and the current are in phase at the...
In an RLC circuit, ? = 10 Ω, ? = 0.5 ??, and ? = 6.0...
In an RLC circuit, ? = 10 Ω, ? = 0.5 ??, and ? = 6.0 ??, the
current in the inductor is ?? = 12 ? sin(?? + 0.2). The circuit
operates at half of the resonance frequency.
a) Find the current in the resistor, capacitor and for the
entire circuit.
b) Find the voltage in the resistor, capacitor, and
inductor.
c) Find the emf of the AC source.
Will give great review for good answer.
2) In an...
Part A: What is the impedance of the circuit? Part B: What is the current amplitude?...
Part A: What is the impedance of the circuit?
Part B: What is the current amplitude?
Part C: What is the phase angle of the source voltage with
respect to the current?
Part D: Does the source voltage lag or lead the current?
Part E: What is the voltage amplitude across the resistor?
Part F: What is the voltage amplitude across the inductor?
Part G: What is the voltage amplitudes across the capacitor?
Constants You have a resistor of resistance...
An ac series circuit consists of a voltage source of frequency f = 60 Hz and...
An ac series circuit consists of a voltage source of frequency f = 60 Hz and voltage amplitude V, a resistor of resistance R = 593 Ω, and a capacitor of capacitance C = 2.8×10−6F. What must the source voltage amplitude V be for the average electrical power consumed in the resistor to be 382 watts? There is no inductance in the circuit.
A series RLC circuit has a capacitor with a capacitance of 36.0 μF , an inductor...
A series RLC circuit has a capacitor with a capacitance of 36.0 μF , an inductor with an inductance of 0.700 H and a resistor with a resistance of 143 Ω. The circuit is attached to a source that has a rms voltage of 65.0 V and a frequency of 91.0 Hz. What is the peak current?
An inductor is hooked up to an AC voltage source. The voltage source has EMF V0...
An inductor is hooked up to an AC voltage source. The voltage source has EMF V0 and frequency f. The current amplitude in the inductor is I0. What is the reactance XL of the inductor? What is the inductance L of the inductor? An rms voltage of 19.5 V with a frequency of 1.20 kHz is applied to a 0.365 μF capacitor. What is the rms current in this circuit? By what factor does the current change if the frequency...
A series AC circuit contains a resistor, an inductor of 250 mH, a capacitor of 4.50...
A series AC circuit contains a resistor, an inductor of 250 mH, a capacitor of 4.50 uF, and a source with AV = 240 V operating at 50.0 Hz. The max maximum current in the circuit is 170 mA. (a) Calculate the inductive reactance. The inductive reactance depends on the value of the inductance and the frequency of the source. Q (b) Calculate the capacitive reactance. (c) Calculate the impedance. kn (d) Calculate the resistance in the circuit. kn. (e)...
A resistor, 50.0-mH inductor, and 100.0-uF capacitor are connected in series with a 50-Hz voltage source....
A resistor, 50.0-mH inductor, and 100.0-uF capacitor are connected in series with a 50-Hz voltage source. The maximum voltage through the circuit is 240 V. Calculate the power across the LCR circuit, if phase angle between the current and voltage is 60degrees.
3. Consider the AC circuit shown in the figure below, consisting
of an alternating voltage source—of voltage V (t) = V0 cos (ωt)—a
capacitor (of capacitance C), an inductor (of inductance L), and
two resistors (of resistances R1 and R2). Also, note the
highlighted points a and b in the circuit. (a) While explaining
your reasoning, determine the necessary condition that must be
satisfied between the circuit elements such that the potential
difference between points a and b is zero...
A series LRC circuit is driven by an ac source with a voltage amplitude of 36.0 V and a frequency of 60.0 Hz. The resistance is 160 Ohm, the inductance is 0.230 H, and the capacitance is 70.0 mu F. a) Determine the impedance of the circuit. b) Determine the current amplitude. c) Determine the voltage amplitude across (i) the resistor, (ii) the inductor and (iii) the capacitor. d) Sketch the phasor diagram (at t = 0) for the circuit,...
In an RLC circuit, ? = 10 Ω, ? = 0.5 ??, and ? = 6.0 ??, the
current in the inductor is ?? = 12 ? sin(?? + 0.2). The circuit
operates at half of the resonance frequency.
a) Find the current in the resistor, capacitor and for the
entire circuit.
b) Find the voltage in the resistor, capacitor, and
inductor.
c) Find the emf of the AC source.
Will give great review for good answer.
2) In an...
Part A: What is the impedance of the circuit?
Part B: What is the current amplitude?
Part C: What is the phase angle of the source voltage with
respect to the current?
Part D: Does the source voltage lag or lead the current?
Part E: What is the voltage amplitude across the resistor?
Part F: What is the voltage amplitude across the inductor?
Part G: What is the voltage amplitudes across the capacitor?
Constants You have a resistor of resistance...
A series AC circuit contains a resistor, an inductor of 250 mH, a capacitor of 4.50 uF, and a source with AV = 240 V operating at 50.0 Hz. The max maximum current in the circuit is 170 mA. (a) Calculate the inductive reactance. The inductive reactance depends on the value of the inductance and the frequency of the source. Q (b) Calculate the capacitive reactance. (c) Calculate the impedance. kn (d) Calculate the resistance in the circuit. kn. (e)...
Most questions answered within 3 hours.
-
Let X be a continuous random variable whose PDF is Let X be a
continuous random...
asked 5 minutes ago -
Martinez Company’s relevant range of production is 7,500 units
to 12,500 units. When it produces and...
asked 3 minutes ago -
A football with a mass of 1.2 kg is kicked from ground level to
a height...
asked 8 minutes ago -
Remember: Changes in supply determinants shift supply, and
changes in demand determinants shift demand. We say...
asked 7 minutes ago -
Why is the answer b), for this question? I came up with C) for
my incorrect...
asked 13 minutes ago -
Suppose that you know that in the population of full-time
employees in the United States, the...
asked 35 minutes ago -
This experiment was designed originally to sample various meat and carcass quality
aspects of Ontario pigs...
asked 35 minutes ago -
Dopamine Hydrochloride: draw the structure And Show the
functional groups in different colors and label the...
asked 28 minutes ago -
A rope supports a 10 kg dumbbell hanging from it. What is the
tension in the...
asked 27 minutes ago -
) Raw materials are studied for contamination. Suppose that
the number of particles of contamination per...
asked 50 minutes ago -
After running a regression analysis we calculated an F test and
the significance level was 0.15....
asked 45 minutes ago -
----Can someone please help me solve this one using JAVA
----I thank you in advance
Create...
asked 50 minutes ago