A square loop of wire of side 2.6 cm and electrical resistance 79 ohm is near...
A very long wire and a square loop of wire lie in the plane of the page as shown. Each side of the square is 15 cm in length, the resistance of the loop is 0.6 Ω, and the near side of the loop is 3 cm from the long wire. The current in the long wire is to the right and is increasing. At the moment, the current in the long wire is 6.5 A. The magnetic flux through...
A square loop of wire with side length 10 cm is moving to the right with constant speed of 16 m/s. The loop has total resistance of .8 ohms. It begins in a region with no magnetic field, then enters a region of magnetic field (wider than 10 cm) with a strength of .5 T pointing out of the page. a) while entering the field what is the direction of the induced current as seen from above the plane of...
A square loop 32.8 cm on a side has a resistance of 6.72 Ohm. It is initially in a 0.654 T magnetic field, with its plane perpendicular to vector B, but is removed from the field in 32.2 ms. Calculate the electric energy dissipated in this process.
A square loop of wire with side length a carries a current I1. The center of the loop is located a distance d from an infinite wire carrying a current I2. The infinite wire and loop are in the same plane; two sides of the square loop are parallel to the wire and two are perpendicular as shown. (Figure 1)Part AWhat is the magnitude, F, of the net force on the loop?Express the force in terms of I1, I2, a,...
A square loop of wire with a small resistance is moved with
constant speed from a field free region into a region of uniform B
field (B is constant in time) and then back into a field free
region to the left. The self inductance of the loop is
negligible.
When entering the field the coil experiences a magnetic force to
the left.
When leaving the field the coil experiences a magnetic force to the
right.
Upon entering the field,...
(11%) Problem 7: A square loop of side length a =2.2 cm is placed a distance b= 1.1 cm from a long wire carrying a current that varies with time at a constant rate, i.e. I(t) = Qt, where Q = 3.6 A/s is a constant. a b A 25% Part (a) Find an expression for the magnetic field due to the wire as a function of time t at a distance r from the wire, in terms of a,...
A square loop of wire with side length 10 cm is moving to the right with constant speed of 16 m/s. The loop has total resistance of 0.8 ohms. It begins in a region with no magnetic field, then enters a region of magnetic field (wider than 10 cm) with a strength of 0.5 T pointing into the page. Finally it leaves the field. 21) While entering the field what is the direction of the induced current as seen from above...
A square, single-turn wire loop ℓ = 1.00 cm on a side is placed
inside a solenoid that has a circular cross section of radius r =
3.00 cm, as shown in the end view of the figure below. The solenoid
is 24.5 cm long and wound with 104 turns of wire.
(a) If the current in the solenoid is 2.30 A, what is the
magnetic flux through the square loop?
T · m2
(b) If the current in the...
A rectangular wire loop located in the plane of the page has a width L, and its length. X. is determined by the position a movable rail that forms the fourth side of the rectangle, as shown. The total electrical resistance of the wire loop is R, and an externally applied magnetic field, B, is directed out of the page. The rail is moving towards the right with speed v. Assume that the x direction is towards the right of...
1. A square loop of wire with one side of a and resistance R is
placed in a uniform magnetic field of strength B. The field
vanishes and results an induced current I in the loop.
( a) a) What is the rate of change of magnetic flux
in terms of I and R?
(b) Magnetic field B (on the picture above) was equal to 0.5 T
before it vanished. If the duration of switch is 0.15 sec and the...