A chandelier is suspended using two chains which makes an angle of = 40° and θ2=150°...
A 100 kg box is suspended from two ropes. The "left rope makes an angle of 20" degrees with the vertical, and the right rope makes an angle of 40 degrees. What is the tension (in Newtons) on the left rope?
A 3.00-m-long, 150-N, uniform rod at the zoo is held in a horizontal position by two ropes at its ends in (Figure 1). The left rope makes an angle of 150∘ with the rod and the right rope makes an angle θ with the horizontal. A 90-N howler monkey (Alouatta seniculus) hangs motionless 0.50 m from the right end of the rod as he carefully studies you. part a: Calculate the tension in the left rope. Express your answer to...
#4 please A uniform sheet of metal in the shape of a hemisphere of radius 1 m is used as a sign. The hemisphere has a mass of 200 kg and is suspended by two vertical wires attached to points along its horizontal diameter. One wire is attached to the left end of the diameter and the other is attached to a point three-quarters of the way to the other end. What is the tension in each wire? A ladder...
ements Constants ents SOLUTION We will look at an example where several forces are acting on an object, but in this case the forces are not all along the same axis. As shown in (Figure 1), a car engine with weight to hangs from a chain that is linked at point to two other chains, one fastened to the ceiling and the other to the wall. Find the tension in each of the three chains, assuming that is given and...
Suppose the tractor pulls horizontally on the sled instead of at an angle of 36.9. As a result, the magnitude of the friction force increases to 4400N. What is the total work done on the sled? Answer: 1.20x10 J onedo 72 Work 187 SOLUTION The statement of the problem gives the hright h rather than the distance s measured along the ramp, but we can solve for h by recogsizing from the geometry in Figare 7.13 that s sinB- h....
Consider the equilibrium of a foot for a crouching 220-lb person. The force through the Achilles tendon (T), the force of the tibia (F), and the normal force (N) from the floor are shown in the figure below. The weight of the foot has been neglected for simplicity. Take the angle that the Achilles tendon makes with the horizontal to be a 36 degrees 2.35" 1.9 What is the normal force (N) on the foot? (Express your answer to two...
Instructions: 1. Draw the schematic of the situation described in the wording of the problem. This schematic includes a list of the data given in the wording of the problem, such as initial position (x, yo), initial velocity Ivo, V, Vol, final position (x,y), final velocity (V, V, W) or maximum height (ym). Make a decision on whether you want to use "y" or "h" for the vertical axis and keep it consistent throughout all the problems. Write down the...
the question is in last picture. i provided the lab content... I need guidance. thank you. INVESTIGATION 10 ROTATIONAL MOTION OBJECTIVE To determine the moment of inertia I of a heavy composite disk by plotting measured values of torque versus angular acceleration. THEORY Newton's second law states that for translational motion (motion in a straight line) an unbalanced force on an object results in an acceleration which is proportional to the mass of the object. This means that the heavier...
Consider a cylindrical capacitor like that shown in Fig. 24.6. Let d = rb − ra be the spacing between the inner and outer conductors. (a) Let the radii of the two conductors be only slightly different, so that d << ra. Show that the result derived in Example 24.4 (Section 24.1) for the capacitance of a cylindrical capacitor then reduces to Eq. (24.2), the equation for the capacitance of a parallel-plate capacitor, with A being the surface area of...