A power transmission line carries 500 A of current at a voltage of 840 kV. If...
A power transmission line carries 500 A of current at a voltage of 840 kV. If the line has a resistance of 24 µΩ/m, what is the rate at which energy is being dissipated in 600 km of line?
Homework Answers
total resistance of line =
24*10-6X600*103 = 14.4 
power loss = I2R = 3600000
Add Answer to:
A power transmission line carries 500 A of current at a voltage
of 840 kV. If...
4. A high-voltage transmission line with a resistance of 0.31.2/km carries a current of 1000 A....
4. A high-voltage transmission line with a resistance of 0.31.2/km carries a current of 1000 A. The line is at a potential of 700kV at the power station and carries the current to a city located 160 km from the station. What is the power loss due to resistance in the line? b) What fraction of the transmitted power does this loss represent?
In an ideal 1:8 step-down transformer, the primary power is 10 kW and the primary voltage...
In an ideal 1:8 step-down transformer, the primary power is 10 kW and the primary voltage is 4kV. What is, a) the primary current? b) the secondary voltage? c) the secondary current? The secondary is connected to a power transmission line. If the line has a resistance of 29 ㎕2m, what is the rate at which energy is being dissipated in 800 km of line? If 8:1 step up transformer is used, what is the rate at which energy is...
Two three-phase power transmission lines with a nominal operating voltage of 220 kV and a frequency...
Two three-phase power transmission lines with a nominal
operating voltage of 220 kV and a frequency of 60 Hz are connected
in series as shown below.
Per-phase constants of the first 110 km long energy transmission
line (E.İ.H.-1); r = 0.01035Ω / km, L = 1.554 mH / km, and C =
7.387 ∙ 10-3 µF / km. Constants per phase of the second 100 km long
energy transmission line (E.İ.H.2); Zh = 1.035 + j58.58 Ω / phase
and...
power system A single-circuit 60-Hz high voltage power transmission line is 370 km (230 mi) long....
power system
A single-circuit 60-Hz high voltage power transmission line is 370 km (230 mi) long. The conductors are Rook with flat horizontal configuration and 7.25 ms=(23.8 ft.) conductor spacing. The load on the line is 125 MW at 100% power factor. Use attached Tables A3 to A3to determine; The sending end voltage Vs The sending end current Is The sending end power Ps The percentage voltage regulation The transmission efficiency Given that Ds for the Rook conductor is 0.0327...
A 230-kV, three-phase transmission line has a per phase series impedance of z = 0.05j0.45 2...
A 230-kV, three-phase transmission line has a per phase series impedance of z = 0.05j0.45 2 per km and a per phase shunt admittance ofy = j3.4 x 10-6 siemens per km. The line is 80 km long. Using the nominal r model, determine (a) The transmission line ABCD constants. Find the sending end voltage and current, voltage regulation, the sending end power and the transmission efficiency when the line delivers (b) 200 MVA, 0.8 lagging power factor at 220...
Phase of a three-phase, 60 Hz, 300 km long power transmission line with a nominal operating...
Phase of a three-phase, 60 Hz, 300 km long power transmission line with a nominal operating line voltage of 500 kV. its inductance per 291 mH/phase, and its capacitance is 3.45uF/phase. Voltage between 500 kV phases from the end of the energy transmission line Under it, a load of 1000 MVA is fed with a power factor of 0.8 back. Power transmission line lossless assumption. This according to the operating conditions, a.) The line's phase constant (61), characteristic impedance (ZC)...
QUESTIONS 1- A 69-kV, three-phase transmission line is 20 km long. The line has a per...
QUESTIONS 1- A 69-kV, three-phase transmission line is 20 km long. The line has a per phase series impedance of 0,120 + 10,4325 per km. Detemine the sending end voltage, voltage regulation, the sending end power, and the transmission efficiency when the line delivers (a) 60 MVA, 0.8 lagging power factor at 60 kV. (b) 110 MW, unity power factor at 60 kV
30,000 kW at power factor 0·8 lagging is being transmitted over a 220 kV, three-phase transmission...
30,000 kW at power factor 0·8 lagging is being transmitted over a 220 kV, three-phase transmission line. The length of the line is 275 km and the efficiency of transmission is 90%. Calculate the weight of copper required. Also calculate the weight of copper had the power been transmitted over a single-phase transmission line for the same line voltage and losses. Assume that the resistance of 1 km long conductor and 1 sq. cm is 0·l73 Ω and specific gravity...
A 250 kV power transmission line carrying 5.00 ✕ 102 A is hung from grounded metal...
A 250 kV power transmission line carrying 5.00 ✕ 102 A is hung from grounded metal towers by ceramic insulators, each having a 2.00 ✕ 109 Ω resistance. (a) What is the resistance to ground in ohms of 145 of these insulators? (Assume the insulators are connected in parallel.) Ω (b) Calculate the power in watts dissipated by 145 of them. W (c) What fraction of the power carried by the line is this? P Ptot =
Suppose a large power plant generates electricity at 12.0 kV. Its old transformer once converted this voltage to kV. The secondary coil of this transformer is being replaced so that its output can be...
Suppose a large power plant generates electricity at 12.0 kV. Its old transformer once converted this voltage to kV. The secondary coil of this transformer is being replaced so that its output can be 730 kV for more efficient cross-country transmission on upgraded transmission lines V 315 kV V2 730 kV - 50% Part (a) If the overall power output is 1000.0 MW and line resistance is 2.00 Ω, what was the power loss, in watts, in the old power...
4. A high-voltage transmission line with a resistance of 0.31.2/km carries a current of 1000 A. The line is at a potential of 700kV at the power station and carries the current to a city located 160 km from the station. What is the power loss due to resistance in the line? b) What fraction of the transmitted power does this loss represent?
In an ideal 1:8 step-down transformer, the primary power is 10 kW and the primary voltage is 4kV. What is, a) the primary current? b) the secondary voltage? c) the secondary current? The secondary is connected to a power transmission line. If the line has a resistance of 29 ㎕2m, what is the rate at which energy is being dissipated in 800 km of line? If 8:1 step up transformer is used, what is the rate at which energy is...
Two three-phase power transmission lines with a nominal
operating voltage of 220 kV and a frequency of 60 Hz are connected
in series as shown below.
Per-phase constants of the first 110 km long energy transmission
line (E.İ.H.-1); r = 0.01035Ω / km, L = 1.554 mH / km, and C =
7.387 ∙ 10-3 µF / km. Constants per phase of the second 100 km long
energy transmission line (E.İ.H.2); Zh = 1.035 + j58.58 Ω / phase
and...
power system
A single-circuit 60-Hz high voltage power transmission line is 370 km (230 mi) long. The conductors are Rook with flat horizontal configuration and 7.25 ms=(23.8 ft.) conductor spacing. The load on the line is 125 MW at 100% power factor. Use attached Tables A3 to A3to determine; The sending end voltage Vs The sending end current Is The sending end power Ps The percentage voltage regulation The transmission efficiency Given that Ds for the Rook conductor is 0.0327...
A 230-kV, three-phase transmission line has a per phase series impedance of z = 0.05j0.45 2 per km and a per phase shunt admittance ofy = j3.4 x 10-6 siemens per km. The line is 80 km long. Using the nominal r model, determine (a) The transmission line ABCD constants. Find the sending end voltage and current, voltage regulation, the sending end power and the transmission efficiency when the line delivers (b) 200 MVA, 0.8 lagging power factor at 220...
Phase of a three-phase, 60 Hz, 300 km long power transmission line with a nominal operating line voltage of 500 kV. its inductance per 291 mH/phase, and its capacitance is 3.45uF/phase. Voltage between 500 kV phases from the end of the energy transmission line Under it, a load of 1000 MVA is fed with a power factor of 0.8 back. Power transmission line lossless assumption. This according to the operating conditions, a.) The line's phase constant (61), characteristic impedance (ZC)...
QUESTIONS 1- A 69-kV, three-phase transmission line is 20 km long. The line has a per phase series impedance of 0,120 + 10,4325 per km. Detemine the sending end voltage, voltage regulation, the sending end power, and the transmission efficiency when the line delivers (a) 60 MVA, 0.8 lagging power factor at 60 kV. (b) 110 MW, unity power factor at 60 kV
Suppose a large power plant generates electricity at 12.0 kV. Its old transformer once converted this voltage to kV. The secondary coil of this transformer is being replaced so that its output can be 730 kV for more efficient cross-country transmission on upgraded transmission lines V 315 kV V2 730 kV - 50% Part (a) If the overall power output is 1000.0 MW and line resistance is 2.00 Ω, what was the power loss, in watts, in the old power...
Most questions answered within 3 hours.
-
Use Cryptool to find the Cryptographic SHA-1 hash value of the
string "abc". The calculator is...
asked 1 minute ago -
You are attempting to calculate a firm’s free cash flow to
equity. You know the following...
asked 52 minutes ago -
the following reaction occurs in a balloon containing
N2O2 gas
N2O4(g)=2NO2(g)
will the volume of the...
asked 1 hour ago -
answer the questions throughout this program
public class Day implements Comparable {
Private Boolean atWork;...
asked 1 hour ago -
This is C++ code for parking fee management program
#include <iostream>
#include <iomanip>
using namespace std;...
asked 1 hour ago -
The free energy change for the following reaction at 25 °C, when
[Sn2+] = 1.17 M...
asked 3 hours ago -
An MNE is this kind of industry when competition in one country
is essentially independent of...
asked 5 hours ago -
. For this set of questions, determine what
proportion of a normal distribution is located betweeneach...
asked 5 hours ago -
A college student is employed as a door-to-door newspaper
salesman. Historical data suggests that the student...
asked 6 hours ago -
MATLAB HW 11 problem using Switch Case and Input commands
Write a script file that calculates...
asked 6 hours ago -
Considering gravitational time dilation, calculate the time that
passes in Earth’s surface while 1 hour passes...
asked 6 hours ago -
Minitab Problem: Take the Lake Hume June rainfall data and find
use the processes outlined in...
asked 7 hours ago