Is there any way to convert 1000gpm of water in a 3" diameter pipe to PSI
Below i have attached the solution for this
Is there any way to convert 1000gpm of water in a 3" diameter pipe to PSI
20.1 DuiC vessels 20.13 20.1 A welded water pipe has a diameter of 9 ft and a wall of steel plate 14 in. thick. After fabrication, this pipe was tested under an internal pressure of 225 psi. Calculate the circum- ferential stress developed in the walls of the pipe. 20.2 Calculate the tensile stresses developed (sircumferential 13. 20.14 DuiC vessels 20.13 20.1 A welded water pipe has a diameter of 9 ft and a wall of steel plate 14 in....
3. Water is pumped at an initial pressure of 60.0 psi in the basement to a vertical height of 21.0 m on the eighth floor of an apartment building. The pipe is 8.5 inches in diameter in the basement, but in the cighth floor apartments, the pipes are only 0.75 inches in diameter. a) What is the pressure of the water in the pipes on the eighth floor if all the spigots are closed? b) What is the velocity of...
3. Water is pumped at an initial pressure of 60.0 psi in the basement to a vertical height of 21.0 m on the eighth floor of an apartment building. The pipe is 8.5 inches in diameter in the basement, but in the eighth floor apartments, the pipes are only 0.75 inches in diameter. a) What is the pressure of the water in the pipes on the eighth floor if all the spigots are closed? b) What is the velocity of...
A 3-in.-diameter pipe supplies water with a velocity of 3 ft/s. The pipe is made of commercial steel and the water temperature is 50∘F. Use the equation 1f√=−1.8log[(ε/D3.7)1.11+6.9Re]. Determine the friction factor.
• The diameter of a pipe carrying water changes gradually from 6 in. at A to 18 in. at B. A is 15 ft. lower than B. What will be the difference in pressure, in psi, between A and B, when 6.2 cfs is flowing, loss of energy being neglected.
3. Water is pumped at an initial pressur floor of an apartment building. The pipe is 8.5 in a at an initial pressure of 60.0 psi in the basement to a vertical height of 21.0 m on the eighth apartment building. The pine is 8.5 inches in diameter in the basement, but in the eighth floor apartments, the pipes are only 0.75 inches in diameter. a) What is the pressure of the water in the pipes on the eighth floor...
Water is released from a water tank through a pipe to the atmosphere. The pipe diameter is 8 mm and the length is 6 m. Water temperature is 15 oC. The resistance coefficient of the pipe f = 0.015 and the difference between the water surface and the pipe outlet is 3 m. Determine the exit velocity of water and sketch the Hydraulic Grade Line (HGL) and Energy Grade Line (EGL) along the pipe. Assume that minor loss can be...
A pipe with an inner diameter of 8 inches (0.67 ft) carries water (ρ = 62.4 lbm/ft3, μ = 6.72 x 10-4 lbm/ft ⋅s) horizontally at a flow rate of 3.1 ft3/s. The pipe has been in service for a very long time, so the wall surface has become fairly rough (ε = 0.008 inches). The pipe is 1550 ft long. A) Calculate ΔP over the pipe length in psi B) Suppose the old pipe is now replaced with a...
A horizontal water pipe goes from a large diameter to a small diameter and then back to the first diameter as shown in the figure below. The level of water in the small vertical tubes provides us with information about the water pressure in the two different sizes of pipe. The inside diameter of the larger pipe is 2.85 cm and water travels through both sizes of pipe with a volume flow rate of 1.20 10-4 m3/s. Determine the inside...
Water is flowing through a horizontal pipe with an inside diameter of 8.00cm. The pipe narrows to an inside diameter of 3.75cm. Assume the water is an ideal incompressible fluid. What is the velocity of the fluid initially, v_1 (when It is flowing in the 8.00cm diameter section) if the velocity of the water in the narrow part of the pipe is measured at V_2 = 27m/s? If the initial pressure is known to be 670 kPa what is the...