0/2: According to figure below, write A typical program for the required moves of CNC Machine...
Write a CNC part program to machine 15 mm thick aluminum part shown in the figure. Use an absolute coordinate system. 140 R10 28 40 deep 45 45 155 70 40 $15 20 RIO TOOL CHANHE POINT All dimensions are in mm Three processes are needed to machine the part, 1) Drilling with cutting speed of 1000 rpm and feedrate 70 mm/min. 2) Side milling with cutting speed of 1400 rpm and feedrate 90 mm/min. 3) Slot milling with cutting...
Question 7): Write G-code program to machine the part shown in
the figure below using CNC milling machine. Use sub programming
commands (M98 and M99) in the pocket cutting. Maximum depth of cut
is 5 mm.
Question 7): Write G-code program to machine the part shown in the figure below using CNC milling machine. Use sub programming commands (M98 and M99) in the pocket cutting Maximum depth of cut is 5 mm. 60 50 0 40 100
Question 7): Write...
Write G-code program to machine the part shown in the figure below using a CNC lathe machine. ci R16 Ø100 035 46 36 Given conditions: tool Number 6, absolute coordinate, feed rate 20 mm/min, and spindle speed 500 RPM with CW. TT T Arial • 3 (12pt) E's
Assignment: Write a CNC program to direct the required machining operations given in the table below for the part shown in the figure. Depth Product Tool Spindle speed Feed (S) (S) (F) RPMMVIN d) Operation MM 130 x 130 x 20 TI 020 End Mill 2500 350 5 Profiling DO OPS P1 (0,0) 80 START POINT (-15,-15) We were unable to transcribe this image
An aluminium component is to be machined on a vertical CNC milling machine. The original stock material is a flat piece having dimensions of 125 x 105 x 10 mm3. The top and bottom surfaces of the finished component are not machined in this operation. All other surfaces and features need to be machined. The finished shape has three Æ20-mm holes machined right through and a slot is machined to a depth of 5 mm. The outside dimensions of the...
10.2. Program number. 01008 (Figure 10.16D) Reference point machine home) 60" 2.250 1.500 50 x45 Figure 10.16 Print and tool paths for producing the part for 10.2 Setup Notes: 1 Set X% at the lower left-hand corner 2 Zo is the top of the part CNC Tool and Operations Sheet Tool Operation Tooling Speed (rpm) Feed (ipm) 1 Profile mill contour x 25 deep 25 DIA end mill1600 DIA indicates diameter 01308 (XOYO IS THE LOWER LEFT HAND CORNER) (ZO...
G00 Rapid move G0 X# Y# Z# up to eight axes or GO Z# X# Gol Feed Rate move G 1 X# Y# Z# up to eight axes or G1 Z# X# G02 Clockwise move X# Y#1# J# G03 Counter Clockwise move X# Y#1# G04 Dwell time G04 L# G08 Spline Smoothing On G09 Exact stop check, Spline Smoothing Off G10 A linear feedrate controlled move with a decelerated stop G11 Controlled Decel stop G17 XY PLANE G18 XZ PLANE...