Hi, I need the full worked solution for ALL PARTS of this question please. Final answers to the first 3 parts are given on the right. Neat handwriting is greatly appreciated. Thank you! :)
Hi, I need the full worked solution for ALL PARTS of this question please. Final answers...
Hi,
I need the full worked solution for parts (ii) and
(iii) of this question please :) The final answers to all
parts are given below the questions. I do not need the solution to
part (i). Thank you for your help! (Would greatly appreciate proper
steps with clear handwriting thank you~)
Question 5 A ladder of mass m may be modelled as a uniform rod of length a, stands on a rough horizontal surface at A and rests against...
Hi, I need the full worked solution/explanations for all
parts of this questions please. The final answers to each
part are shown below the question. Clear handwriting is greatly
appreciated. Thank you! :)
Question 5 (a) Solve the eigenvalues and its corresponding eigenvectors of a 2x2 matrix given by 2 0 (8 marks) For the system of differential equations, Зх — у ў 2х + 6е ". (b) Write and explain the system of differential equations in matrix form. (2...
Hi, I need the full worked
solution/explanations for ALL parts of
this question please. Please do not skip steps and
underline all final answers. The final answers to all
parts are provided below the question. Neat handwriting is greatly
appreciated. Thank you! :)
Question 4 Consider the contour curve given by (а) Identify a unit vector perpendicular to the curve at the point (-1, 1) (4 marks) (b) Consider the scalar field fx, y, )y-y+xyz Identify the maximum value of...
ANSWER ALL QUESTIONS: 0-1. Study the circuit diagram given in Figurel and answer the following questions. (1.5 marks) i.) When the square wave voltage is + 5V, the transistor will be in which region? c) Saturation ii.) When the square wave voltage is OV, the transistor will be in which region? a) Cutoff region b) Saturation c) Active region iii.) When transistor operates in Saturation region, what are the values of Vce, and Ic? iv.) When transistor operates in Cutoff...
Hi,
I need the full worked solutions (step-by-step with
explanations where necessary) for all parts of this
question please. The final answers to each part are given below the
questions. Would greatly appreciate neat handwriting and clear
steps. Thank you! :)
Question 4 A uniform rod AB of weight W and length 2a, rests in equilibrium with its end A against a smooth vertical wall PQ, and its end B on a rough inclined plane OQ at an angle a...
Please answer all the parts of the question clearly and fully!
Thank you!
Numerical Answers:
(b) (0.0 A, 24 V), (approximately 1.6 A, 0.32 V)
(c) 38.4 W, 0.5 W
(e) 0.26 W + 1.5 mW
SECTION B: Attempt any Two) questions 150 marks total! Q3 A MOSFET is used as a low-side switch to control a 15 2 resistive load from a 24 supply. The MOSFET has RDSan VDC 0.2 ? and ton-tof-40 ns. (a) Draw a suitable circuit....
Hi,
I need the full worked solution (step-by-step with clear
explanations where possible) for all
parts of this question, please. The final answers to all
the parts are given below the questions. Would greatly appreciate
neat handwriting with clear steps. Thank you! :)
Question 6 A particle of mass m is projected vertically upwards with an initial speed vo in a fluid. The magnitude of the resistive force is kv, where v is the speed of the particle and k...
A common source amplifier circuit based on a single n-channel MOSFET is shown in Figure 4b. Assume that the transconductance gm-60 mS (equivalent to mA/ V) and drain source resistance, os, is so large it may be neglected. 0) Calculate the open circuit voltage gain Av Yout/ Vis. i) The amplifier has a load of 10 k2. Determine the current gain Va. = 12 V 150k 4k3 Vout Vin 200k GND = 0 V Figure 4b a) State the name...
Questions and answers are here, need solution process.
3. a) For the circuit shown in Figure Q3 (a): i) Find the mathematical expression for the transient behaviour of the voltage 6 vc across the capacitor and the current ic when the switch is moved into position 1 at t- 0 s ii) Find the mathematical expression for the response of vc and ic if the switch 4 is moved into position 2 at t charging phase) τ (where τ is...
HI, PLEASE ANSWER ALL PARTS AND PLEASE SHOW ALL WORKINGS STEP BY STEP. THANK YOU. Question 1: a) Show from first principles that the Laplace transform of the function f(n)=1, 120 is f(s) = Make a note of any conditions imposed on the transform variable "s" to ensure the transform exists. (8 Marks) b) Find, using the appropriate theorem, the Laplace transform of a function f(t); b) f(t) = t.sin(56) OR ii) f(t) = 5 sin 2(t - 3). H(t...